Difficulty
Difficult
Steps
9
Time Required
25 minutes
Sections
1
- Screen
- 9 steps
Flags
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackToshiba Satellite L875D-S7210
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Locate the round stickers on each corner of the screen covering the screws. Use a sharp tool, such as a pointy metal spudger or tweezers, to gently remove these stickers.
Locate the round stickers on each corner of the screen covering the screws. Use a sharp tool, such as a pointy metal spudger or tweezers, to gently remove these stickers.
1024
Step 2
- Unscrew the screws using a Phillips Head #1 screwdriver; there should be four in total, one on each corner.
Unscrew the screws using a Phillips Head #1 screwdriver; there should be four in total, one on each corner.
Step 3
- Take the opening tool and gently place it under the plastic framing the screen. Gently slip the opening tool between the plastic frame and the screen, until a change in pressure is felt, the feeling of the plastic clasps dislodging.
Take the opening tool and gently place it under the plastic framing the screen. Gently slip the opening tool between the plastic frame and the screen, until a change in pressure is felt, the feeling of the plastic clasps dislodging.
Step 4
- Repeat this process along the interior edges of the plastic frame. Once the all plastic locks are unhooked the plastic frame should fall off the screen.
Repeat this process along the interior edges of the plastic frame. Once the all plastic locks are unhooked the plastic frame should fall off the screen.
Step 5
- Locate the two screws at the bottom corners of the screen.
Locate the two screws at the bottom corners of the screen.
Step 6
- Using the same screwdriver (Phillips Head #1), unscrew all the screws on both sides of the screen.
Using the same screwdriver (Phillips Head #1), unscrew all the screws on both sides of the screen.
Step 7
- Find and unscrew the six screws (3 on each side) on the sides of the screen. Be careful while unscrewing the last few screws as the screen will still be attached to the computer in two different places and may fall out of its casing.
Find and unscrew the six screws (3 on each side) on the sides of the screen. Be careful while unscrewing the last few screws as the screen will still be attached to the computer in two different places and may fall out of its casing.
Step 8
- At the top of the computer, there should be a cable still wired to the detached screen. Gently pull the head of the cable away from its connector until the cable dislodges.
At the top of the computer, there should be a cable still wired to the detached screen. Gently pull the head of the cable away from its connector until the cable dislodges.
Step 9
- At the back of the screen, there will be one more connector at the bottom. Remove the tape to disconnect this wire.
At the back of the screen, there will be one more connector at the bottom. Remove the tape to disconnect this wire.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Ian M Sloop
Member since: 10/20/2018
667 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
UC Davis, Team S7-G7, Lore Fall 2018
Member of UC Davis, Team S7-G7, Lore Fall 2018
UCD-LORE-F18S7G7
4 Members
4 Guides authored
