Difficulty
Moderate
Steps
7
Time Required
15 - 45 minutes
Sections
3
- Battery
- 1 step
- Keyboard
- 3 steps
- Optical Disc Drive
- 3 steps
Flags
0
BackToshiba Satellite L755D-S5150
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- After shutting down your laptop, turn your laptop over and click the left tab left, then pull the right tab right as you pull the battery out.
- This step should always be done before working on your laptop to minimize electrostatic shock.
After shutting down your laptop, turn your laptop over and click the left tab left, then pull the right tab right as you pull the battery out.
This step should always be done before working on your laptop to minimize electrostatic shock.
1024
Step 2
Keyboard
- Using the plastic opening tool carefully pry the plastic strip that sits at the top of the keyboard.
Using the plastic opening tool carefully pry the plastic strip that sits at the top of the keyboard.
Step 3
- Use the Phillips PH00 to unscrew the four 4mm screws that holds the keyboard in place.
- Using the plastic opening tool carefully pry your keyboard out without disturbing the cord underneath it.
Use the Phillips PH00 to unscrew the four 4mm screws that holds the keyboard in place.
Using the plastic opening tool carefully pry your keyboard out without disturbing the cord underneath it.
Step 4
- Remaining is the cord that connects the keyboard to the motherboard. Remove this cord after the tabs are pressed in that releases keyboard.
Remaining is the cord that connects the keyboard to the motherboard. Remove this cord after the tabs are pressed in that releases keyboard.
Step 5
Optical Disc Drive
- Use the screwdiver and the Phillips PH00 to unscrew the three, 4mm screws for the RAM compartment
Use the screwdiver and the Phillips PH00 to unscrew the three, 4mm screws for the RAM compartment
Step 6
- Use the Phillips PH00 to remove the 4mm screw that holds the ODD.
- Slide the ODD outward.
Use the Phillips PH00 to remove the 4mm screw that holds the ODD.
Slide the ODD outward.
Step 7
- Remove the two 4mm screws and the plate attached to the ODD.
Remove the two 4mm screws and the plate attached to the ODD.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 6 other contributors
Michael Griskewicz
Member since: 10/06/2016
147 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
USF Tampa, Team 2-5, Sullivan Fall 2016
Member of USF Tampa, Team 2-5, Sullivan Fall 2016
USFT-SULLIVAN-F16S2G5
4 Members
5 Guides authored