Difficulty
Easy
Steps
6
Time Required
4 - 6 minutes
Sections
1
- RAM
- 6 steps
Flags
0
BackToshiba Satellite L755-S5244
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RAM
- Loosen the two 3mm Phillips #0 screws securing the hard drive panel. The panel will retain the screws, so do not remove them completely.
- Remove the panel from the laptop (the hard drive does not need to be removed).
Loosen the two 3mm Phillips #0 screws securing the hard drive panel. The panel will retain the screws, so do not remove them completely.
Remove the panel from the laptop (the hard drive does not need to be removed).
1024
Step 2
- Loosen the three 3mm Phillips #0 screws that secure the center panel. The screws are retained by the cover, so do not remove them completely.
- Remove the panel by pulling out to the right.
- The two RAM sticks are stacked, one on top of the other.
Loosen the three 3mm Phillips #0 screws that secure the center panel. The screws are retained by the cover, so do not remove them completely.
Remove the panel by pulling out to the right.
The two RAM sticks are stacked, one on top of the other.
Step 3
- Each RAM stick has two (2) snap locks, one on each end. In the image the bottom snap is obscured by the cable.
Each RAM stick has two (2) snap locks, one on each end. In the image the bottom snap is obscured by the cable.
Step 4
- Move the retaining clips out of their locking position, allowing the RAM stick to pop up.
- Lift the free end of the RAM stick until the stick can be freely removed from its slot.
Move the retaining clips out of their locking position, allowing the RAM stick to pop up.
Lift the free end of the RAM stick until the stick can be freely removed from its slot.
Step 5
- The RAM stick has a notch that is not centered on the stick. Be sure to take note of the RAM stick’s orientation for reinstallation
The RAM stick has a notch that is not centered on the stick. Be sure to take note of the RAM stick’s orientation for reinstallation
Step 6
- Repeat for the second RAM stick.
Repeat for the second RAM stick.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Carter Willson
Member since: 04/15/2019
248 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
Oregon Institute of Technology, Team S1-G5, Lancaster Spring 2019
Member of Oregon Institute of Technology, Team S1-G5, Lancaster Spring 2019
OIT-LANCASTER-S19S1G5
4 Members
6 Guides authored