Toshiba Satellite L15W B1303 Usb Port Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          5 minutes            

Sections

2

• Bottom Panel
• 1 step
• USB Port
• 3 steps

Flags

1

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

• BackToshiba Satellite L15W-B1303

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Before attempting a replacement ensure you have consulted the troubleshooting page to ensure your problem requires the replacement of the ports.

The Toshiba Satellite L15W-B1303 laptop comes with the now outdated standard USB 2.0. If you wish to have a faster connection to make better use of supported external storage devices, you may wish to consider finding a USB adapter supporting the newer standard of USB 3.0 or above.

Before opening your device, ensure you have removed any external power sources from the device to avoid damage to your device or yourself.

Be sure to back up your hard drive before replacing it so you don’t lose any data while you’re doing the replacement. Make sure to power off your laptop completely and disconnect from any external power source prior to beginning the process.

What you need

Step 1

              Bottom Panel               

• Turn the laptop over and place it on its top side.
• Remove ten 10mm JIS #00 screws from the bottom panel of the laptop.
• Using the iFixit opening tool, remove the bottom panel of the laptop.

Turn the laptop over and place it on its top side.

Remove ten 10mm JIS #00 screws from the bottom panel of the laptop.

Using the iFixit opening tool, remove the bottom panel of the laptop.

1024

Step 2

              USB Port               

• Disconnect the cable that connects the receiver to the laptop using the pointed end of a spudger.

Disconnect the cable that connects the receiver to the laptop using the pointed end of a spudger.

Step 3

• Remove the single JIS #00 screw.

Remove the single JIS #00 screw.

Step 4

• Peel back the material covering this wire.
• Gently pull the board out carefully to avoid damaging the connector.

Peel back the material covering this wire.

Gently pull the board out carefully to avoid damaging the connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Justin Caruso                     

Member since: 01/22/2020

147 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       York University, Team S8-G2, Turner Winter 2020                        

                                                  Member of York University, Team S8-G2, Turner Winter 2020 



                    YORK-TURNER-W20S8G2                     


                                            5 Members                     


                                            10 Guides authored