Difficulty
Moderate
Steps
9
Time Required
10 minutes
Sections
2
- Battery
- 6 steps
- Network Card
- 3 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackToshiba Satellite CL15t-B1204X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery
- Flip the laptop over so the bottom of the device is facing upward.
Flip the laptop over so the bottom of the device is facing upward.
1024
Step 2
- Unscrew the 10 5mm Phillips screws, located on the bottom side of the notebook using the PH1 bit and the Magnetic Driver.
Unscrew the 10 5mm Phillips screws, located on the bottom side of the notebook using the PH1 bit and the Magnetic Driver.
Step 3
- Pry open the bottom cover of the notebook with the plastic spudger tools. Slide a thin tool along the edges without ports to pop open the latches.
- Be careful not to bend or crack the plastic back cover.
Pry open the bottom cover of the notebook with the plastic spudger tools. Slide a thin tool along the edges without ports to pop open the latches.
Be careful not to bend or crack the plastic back cover.
Step 4
- Remove the 1" yellow tape on top of the battery. This piece of tape is holding down the battery connection cable.
Remove the 1" yellow tape on top of the battery. This piece of tape is holding down the battery connection cable.
Step 5
- Lightly grip the battery on the two longest sides. Gently pull up until the adhesive on the notebook is separated from the battery.
Lightly grip the battery on the two longest sides. Gently pull up until the adhesive on the notebook is separated from the battery.
Step 6
- Carefully unplug the battery from the device motherboard.
Carefully unplug the battery from the device motherboard.
Step 7
Network Card
- Peel off the black antenna stuck to the card.
Peel off the black antenna stuck to the card.
Step 8
- Carefully use the PH1 screw head to unscrew the one 3mm screw on the network card found near the hinge at the top.
Carefully use the PH1 screw head to unscrew the one 3mm screw on the network card found near the hinge at the top.
Step 9
- Remove the network card.
Remove the network card.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Royce Alexander Porter
Member since: 09/10/2018
643 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
Appalachian State University, Team S2-G3, Menagarishvili Fall 2018
Member of Appalachian State University, Team S2-G3, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G3
3 Members
9 Guides authored