Difficulty

Moderate

Steps

7

Time Required

                          10 minutes

Sections

3

  • Battery
  • 3 steps
  • Back Access Panel
  • 1 step
  • Hard-Drive
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackToshiba Satellite C75D-A7370

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • To begin replacing your battery, flip the laptop over so that the back is visible. Locate the battery at the bottom center of the laptop.
  • Before beginning battery removal, make sure that no power source is connected to the laptop. This will avoid electrical shock.

To begin replacing your battery, flip the laptop over so that the back is visible. Locate the battery at the bottom center of the laptop.

Before beginning battery removal, make sure that no power source is connected to the laptop. This will avoid electrical shock.

1024

Step 2

  • On the right side of the battery there will be a locking switch. Slide the switch into the unlocked position.

On the right side of the battery there will be a locking switch. Slide the switch into the unlocked position.

Step 3

  • Using your left hand, move the switch on the left side of the battery towards the center of the laptop while simultaneously prying up on the center of the battery with a spudger. The battery will flip out and can be removed.

Using your left hand, move the switch on the left side of the battery towards the center of the laptop while simultaneously prying up on the center of the battery with a spudger. The battery will flip out and can be removed.

Step 4

              Back Access Panel
  • Remove the 7mm screw near the center of the back of the laptop with a P1 screwdriver and pry off the access panel with a nylon spudger.

Remove the 7mm screw near the center of the back of the laptop with a P1 screwdriver and pry off the access panel with a nylon spudger.

Step 5

              Hard-Drive
  • Locate the hard-drive.

Locate the hard-drive.

Step 6

  • Remove the two 7 mm screws holding the hard-drive in place with a P1 driver

Remove the two 7 mm screws holding the hard-drive in place with a P1 driver

Step 7

  • Then using the tab located on top of the hard-drive pull up towards you and then pull to the left to disconnect the hard-drive. Now you are ready to replace your hard-drive.

Then using the tab located on top of the hard-drive pull up towards you and then pull to the left to disconnect the hard-drive. Now you are ready to replace your hard-drive.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Basim Ismail

Member since: 02/02/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team 16-1, Blackwell Spring 2017                        

                                                  Member of USF Tampa, Team 16-1, Blackwell Spring 2017 



                    USFT-BLACKWELL-S17S16G1                     


                                            3 Members                     


                                            12 Guides authored