Difficulty
Moderate
Steps
6
Time Required
10 minutes
Sections
2
- Battery
- 2 steps
- Keyboard
- 4 steps
Flags
0
BackToshiba Satellite C675-S7106
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip the laptop over, so that the “top” of the laptop is against your working surface.
- Orient the laptop so that the silver label is in the bottom-left corner, with the battery facing you.
Flip the laptop over, so that the “top” of the laptop is against your working surface.
Orient the laptop so that the silver label is in the bottom-left corner, with the battery facing you.
1024
Step 2
- On the right side of the battery, move the tab marked 1 to the right, unlocking the battery.
- On the left side of the battery, hold the tab marked 2 to the left while pulling the battery towards you.
On the right side of the battery, move the tab marked 1 to the right, unlocking the battery.
On the left side of the battery, hold the tab marked 2 to the left while pulling the battery towards you.
Step 3
Keyboard
- Open the laptop with the screen facing you, as if to use it.
Open the laptop with the screen facing you, as if to use it.
Step 4
- Starting at the right, pry up part of the plastic bar by using a spudger between the F12 and Insert key.
- Pull up on the rest of the plastic bar to remove it.
Starting at the right, pry up part of the plastic bar by using a spudger between the F12 and Insert key.
Pull up on the rest of the plastic bar to remove it.
Step 5
- Remove the four 2.5mm M2 screws above the keyboard using a PH0 screwdriver.
Remove the four 2.5mm M2 screws above the keyboard using a PH0 screwdriver.
Step 6
- Once screws are removed, lift the keyboard closest to the screen and gently flip it over.
- Using the spudger, lift up the white ZIF connector to unlatch the ribbon cable, and gently remove the cable.
Once screws are removed, lift the keyboard closest to the screen and gently flip it over.
Using the spudger, lift up the white ZIF connector to unlatch the ribbon cable, and gently remove the cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Dinis Valcorba
Member since: 03/26/2019
292 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
UMass Dartmouth, Team S1-G2, Simcock Spring 2019
Member of UMass Dartmouth, Team S1-G2, Simcock Spring 2019
UMASSD-SIMCOCK-S19S1G2
3 Members
12 Guides authored