Difficulty
Moderate
Steps
6
Time Required
20 minutes
Sections
1
- Screen
- 6 steps
Flags
0
BackToshiba Portege R835-P88
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Remove the battery by pressing the two buttons inward and pulling the battery out.
Remove the battery by pressing the two buttons inward and pulling the battery out.
1024
Step 2
- Remove the end caps located on the left and right corners below the screen.
Remove the end caps located on the left and right corners below the screen.
Step 3
- Remove the square rubber caps on top of the screws
- Remove the 4 mm screws at the top
- remove the two 6 mm screws that were under the chrome caps at the bottom.
Remove the square rubber caps on top of the screws
Remove the 4 mm screws at the top
remove the two 6 mm screws that were under the chrome caps at the bottom.
Step 4
- Remove the plastic bezel by lightly prying on it. It will pop when it starts to come loose.
Remove the plastic bezel by lightly prying on it. It will pop when it starts to come loose.
Step 5
- Remove tape from around cord attached to the bottom of the screen.
- Place the screen on top of the keyboard
Remove tape from around cord attached to the bottom of the screen.
Place the screen on top of the keyboard
Step 6
- Remove the cord from the screen by cutting the tape where the two fittings meet. After that pull them apart.
Remove the cord from the screen by cutting the tape where the two fittings meet. After that pull them apart.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Madison Crawford
Member since: 01/19/2017
101 Reputation
1 Guide authored
Badges:
3
Team
South Arkansas Community College, Team 1-2, Mitchell Spring 2017
Member of South Arkansas Community College, Team 1-2, Mitchell Spring 2017
SACC-MITCHELL-S17S1G2
4 Members
8 Guides authored