Toshiba Portege R500 Audio Usb Port Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes            

Sections

2

• Battery
• 1 step
• Audio/USB Port
• 5 steps

Flags

4

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackToshiba Portege R500

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Battery               

• Make sure the device is off to prevent data loss.
• Slide both latches to the unlocked position to release the battery.
• Switch the latch on the right to reveal red. The latch on the left needs to be held.
• Pull the battery toward you while holding the left latch.

Make sure the device is off to prevent data loss.

Slide both latches to the unlocked position to release the battery.

Switch the latch on the right to reveal red. The latch on the left needs to be held.

Pull the battery toward you while holding the left latch.

1024

Step 2

              Audio/USB Port               

• Remove the sixteen screws at the locations shown with the Phillips 00 screwdriver.

Remove the sixteen screws at the locations shown with the Phillips 00 screwdriver.

Step 3

• Pull up on the back casing and remove it, revealing the audio/usb port.

Pull up on the back casing and remove it, revealing the audio/usb port.

Step 4

• Remove the single 4 mm screw holding the port in place with the Phillips 00 screwdriver.

Remove the single 4 mm screw holding the port in place with the Phillips 00 screwdriver.

Step 5

• Use the plastic opening tool to disconnect the port from its power source on the laptop. This will be the wire connector with the white connection.

Use the plastic opening tool to disconnect the port from its power source on the laptop. This will be the wire connector with the white connection.

Step 6

• Remove the ribbon cable from the port to free it from the laptop.
• Be careful when reconnecting the ribbon cable, it can be difficult.

Remove the ribbon cable from the port to free it from the laptop.

Be careful when reconnecting the ribbon cable, it can be difficult.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    JRJones                     

Member since: 04/19/2013

145 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 2-19, Maness Spring 2013                        

                                                  Member of Cal Poly, Team 2-19, Maness Spring 2013 



                    CPSU-MANESS-S13S2G19                     


                                            3 Members                     


                                            10 Guides authored