Toshiba Nb250 108 Wlan Karte Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Wi-Fi card
2 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

BackToshiba NB250-108
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Remove the battery

Save your work.
Turn off the computer. The LED Power must not light up anymore.
Disconnect all cables and devices connected to the computer.
Close the screen and place the computer face down as shown in the picture.
Slide the safety latch (on the left side of the picture) to the unlocked position (to the left) to activate the release.
Slide the battery release (pictured on the right) to the right side and hold it to release the battery and remove the battery from the back of the computer.

Save your work.

Turn off the computer. The LED Power must not light up anymore.

Disconnect all cables and devices connected to the computer.

Close the screen and place the computer face down as shown in the picture.

Slide the safety latch (on the left side of the picture) to the unlocked position (to the left) to activate the release.

Slide the battery release (pictured on the right) to the right side and hold it to release the battery and remove the battery from the back of the computer.

1024

Step 2

              Remove WLAN card

Now remove the two screws (T6 Torx) of the hard drive and wireless card cover.
Remove the cover by lifting and pulling lightly on the right side.
Disconnect the gray and black wires from the top of the wireless card by pulling them up with fingernails.
Remove the 2 black screws (Phillips # 1) which hold the card in place. Now pull the WLAN card upwards in the direction of the battery out of the slot. Place the wifi card securely on your desktop

Now remove the two screws (T6 Torx) of the hard drive and wireless card cover.

Remove the cover by lifting and pulling lightly on the right side.

Disconnect the gray and black wires from the top of the wireless card by pulling them up with fingernails.

Remove the 2 black screws (Phillips # 1) which hold the card in place. Now pull the WLAN card upwards in the direction of the battery out of the slot. Place the wifi card securely on your desktop

Repeat the steps in order to reassemble your device.

Cancel: I did not complete this guide.

        irlanda is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

irlanda

Author

                                      with 1 other contributor

                    Guenter Hildebrandt

Member since: 12/16/2015

1,027 Reputation

                                      5 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Member-Contributed Guide#

Introduction#

What you need#

#

#

#

#

Member-Contributed Guide

Introduction

What you need