Difficulty

Easy

Steps

2

Time Required

                          5 minutes

Sections

1

  • Hard Drive
  • 2 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackToshiba NB250-108

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove the battery
  • Save your work.
  • Turn off the computer. The LED Power must not light up anymore.
  • Disconnect all cables and devices connected to the computer.
  • Close the screen and place the computer face down as shown in the picture.
  • Slide the safety latch (on the left side of the picture) to the unlocked position (to the left) to activate the release.
  • Slide the battery release (pictured on the right) to the right side and hold it to release the battery and remove the battery from the back of the computer.

Save your work.

Turn off the computer. The LED Power must not light up anymore.

Disconnect all cables and devices connected to the computer.

Close the screen and place the computer face down as shown in the picture.

Slide the safety latch (on the left side of the picture) to the unlocked position (to the left) to activate the release.

Slide the battery release (pictured on the right) to the right side and hold it to release the battery and remove the battery from the back of the computer.

1024

Step 2

              Remove the hard drive
  • Now remove the two screws (T6 Torx) of the hard drive and wireless card cover. Remove the cover by lifting and pulling lightly on the right side.
  • To remove the hard drive, push it gently with both hands at the same time towards the battery. Now it can easily be removed from the shaft.
  • Place the removed hard drive securely on the work surface.

Now remove the two screws (T6 Torx) of the hard drive and wireless card cover. Remove the cover by lifting and pulling lightly on the right side.

To remove the hard drive, push it gently with both hands at the same time towards the battery. Now it can easily be removed from the shaft.

Place the removed hard drive securely on the work surface.

Repeat the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

        Corey Meyer is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

Corey Meyer

Author

                                      with 1 other contributor 


                    Guenter Hildebrandt

Member since: 12/16/2015

1,027 Reputation

                                      5 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges