Difficulty

Easy

Steps

5

Time Required

                          15 - 30 minutes

Sections

2

  • Back Panel
  • 3 steps
  • Speakers
  • 2 steps

Flags

0

  • BackToshiba Excite 10 AT300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove SD Card
  • Remove the SD card from the SD card slot.

Remove the SD card from the SD card slot.

1024

Step 2

              Open the Tablet
  • Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.
  • Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.

Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.

Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.

Step 3

              Disconnect Speaker Wires
  • Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.
  • Be careful not to rip the wires out of the white connector piece.

Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.

Be careful not to rip the wires out of the white connector piece.

Step 4

              Removing Tape
  • Using either your hands or tweezers remove the 3 pieces of tape holding the speaker wires to the back panel.

Using either your hands or tweezers remove the 3 pieces of tape holding the speaker wires to the back panel.

Step 5

              Unscrew Speakers
  • Using a #00 Phillips screwdriver, remove the four 3mm #00 Phillips screws that hold the speakers in place.
  • Using your hands, remove the old speakers from back panel of tablet.
  • Place the new speakers where the old speakers were and in the same orientation.

Using a #00 Phillips screwdriver, remove the four 3mm #00 Phillips screws that hold the speakers in place.

Using your hands, remove the old speakers from back panel of tablet.

Place the new speakers where the old speakers were and in the same orientation.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Andrew Gillis

Member since: 10/09/2014

564 Reputation

                                      3 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Cal Poly, Team 14-26, Maness Fall 2014                        

                                                  Member of Cal Poly, Team 14-26, Maness Fall 2014 



                    CPSU-MANESS-F14S14G26                     


                                            4 Members                     


                                            12 Guides authored