Difficulty
Easy
Steps
7
Time Required
15 - 25 minutes
Sections
3
- Back Panel
- 3 steps
- Battery
- 2 steps
- Front-Facing Camera
- 2 steps
Flags
0
BackToshiba Excite 10 AT300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove SD Card
- Remove the SD card from the SD card slot.
Remove the SD card from the SD card slot.
1024
Step 2
Open the Tablet
- Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.
- Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.
Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.
Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.
Step 3
Disconnect Speaker Wires
- Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.
- Be careful not to rip the wires out of the white connector piece.
Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.
Be careful not to rip the wires out of the white connector piece.
Step 4
Remove Screws
- Using a #00 Phillips screwdriver, remove the following screws:
- Five 3mm Phillips #00 screws
Using a #00 Phillips screwdriver, remove the following screws:
Five 3mm Phillips #00 screws
Step 5
Remove Battery Cable
- Gently lift the battery, pulling away from the tab holding it in place at the bottom.
- While holding the battery up, use a pair of tweezers to remove the battery cable from its connector.
Gently lift the battery, pulling away from the tab holding it in place at the bottom.
While holding the battery up, use a pair of tweezers to remove the battery cable from its connector.
Step 6
Remove the foil wire
- Using tweezers, pull the copper foil up from the back of the camera. It should peel up easily.
- Warning: Be careful to avoid ripping the foil.
Using tweezers, pull the copper foil up from the back of the camera. It should peel up easily.
Warning: Be careful to avoid ripping the foil.
Step 7
Remove the ribbon cable
- Carefully remove the ribbon cable from the housing by pulling gently upwards on the sides of the cable housing. The cable should come straight up off of its housing.
Carefully remove the ribbon cable from the housing by pulling gently upwards on the sides of the cable housing. The cable should come straight up off of its housing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Gus Holz
Member since: 10/09/2014
297 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 14-26, Maness Fall 2014
Member of Cal Poly, Team 14-26, Maness Fall 2014
CPSU-MANESS-F14S14G26
4 Members
12 Guides authored