Difficulty

Easy

Steps

5

Time Required

                          5 - 10 minutes

Sections

2

  • Back Panel
  • 3 steps
  • Battery
  • 2 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackToshiba Excite 10 AT300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove SD Card
  • Remove the SD card from the SD card slot.

Remove the SD card from the SD card slot.

1024

Step 2

              Open the Tablet
  • Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.
  • Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.

Use the opening tool to separate the front and rear panels by slipping the tool underneath the screen edge and sliding it around the entire device.

Make sure you unclip all of the clips on the back panel, or pulling it off will be difficult and may damage the tablet.

Step 3

              Disconnect Speaker Wires
  • Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.
  • Be careful not to rip the wires out of the white connector piece.

Remove the speaker cable from its socket by gripping both sides of the white connector piece with tweezers and pulling straight out.

Be careful not to rip the wires out of the white connector piece.

Step 4

              Remove Screws
  • Using a #00 Phillips screwdriver, remove the following screws:
  • Five 3mm Phillips #00 screws

Using a #00 Phillips screwdriver, remove the following screws:

Five 3mm Phillips #00 screws

Step 5

              Remove Battery Cable
  • Gently lift the battery, pulling away from the tab holding it in place at the bottom.
  • While holding the battery up, use a pair of tweezers to remove the battery cable from its connector.

Gently lift the battery, pulling away from the tab holding it in place at the bottom.

While holding the battery up, use a pair of tweezers to remove the battery cable from its connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      12 other people completed this guide.

Author

                                      with 4 other contributors 


                    Andrew Gillis

Member since: 10/09/2014

564 Reputation

                                      3 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Cal Poly, Team 14-26, Maness Fall 2014                        

                                                  Member of Cal Poly, Team 14-26, Maness Fall 2014 



                    CPSU-MANESS-F14S14G26                     


                                            4 Members                     


                                            12 Guides authored

lajenaolson - May 15, 2016

Reply

My tablet won’t come on what do i do? It was working yesterday with no problem when I plugged it in this morning to charge it while I was gone when I came back it would come on at all . It felt hot.

Jamie Kitchens - Jul 28, 2016

Reply

Thank you kindly. It took 20 minutes total.

Sylvia Chambers - Aug 29, 2016

Reply

My tablet comes but it’s want to go to main screen

Tracy - Dec 20, 2018

Reply

How do I get another battery for my Toshiba tablet