Difficulty

Moderate

Steps

5

Time Required

                          3 - 5 minutes            

Sections

1

  • Battery
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackToshiba Encore 2 WT8-B

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery               
  • Lay the tablet face down.
  • Use the Opening pick at the back of the tablet to free the clips. Begin to pull the tool up slightly and work your way around the tablet to free all the clips.
  • Remove the back panel from the tablet.
  • Using a metal prying tool could damage the device.

Lay the tablet face down.

Use the Opening pick at the back of the tablet to free the clips. Begin to pull the tool up slightly and work your way around the tablet to free all the clips.

Remove the back panel from the tablet.

Using a metal prying tool could damage the device.

1024

Step 2

  • Use a pair of fine tweezers or your fingers to flip up the small retaining flap. Then, you can safely pull the ribbon cable out.
  • Repeat on both ends.
  • Make sure to pull out the hinged flap of the ribbon and not the connector.

Use a pair of fine tweezers or your fingers to flip up the small retaining flap. Then, you can safely pull the ribbon cable out.

Repeat on both ends.

Make sure to pull out the hinged flap of the ribbon and not the connector.

Step 3

  • Remove the attached battery wires by pushing the plastic wire holder from right to left on top and bottom part of plastic holder.
  • Be sure to be very gentle when prying colored wires from motherboard to ensure that there is no damage.

Remove the attached battery wires by pushing the plastic wire holder from right to left on top and bottom part of plastic holder.

Be sure to be very gentle when prying colored wires from motherboard to ensure that there is no damage.

Step 4

  • Use the Phillips #00 screwdriver to remove the seven battery screws connecting the battery to the unit.

Use the Phillips #00 screwdriver to remove the seven battery screws connecting the battery to the unit.

Step 5

  • Remove the battery out of the device.

Remove the battery out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Manfred Rebello                     

Member since: 02/13/2020

145 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       University of North Texas, Team S1-G4, Thomas Spring 2020                        

                                                  Member of University of North Texas, Team S1-G4, Thomas Spring 2020 



                    UNT-THOMAS-S20S1G4                     


                                            3 Members                     


                                            1 Guide authored