Difficulty
Moderate
Steps
10
Time Required
25 minutes
Sections
2
- Battery
- 6 steps
- Motherboard
- 4 steps
Flags
1
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
BackToshiba Encore 2 WT10-A
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Start by holding your Toshiba tablet faced up.
- Flip the tablet from left to right so that you are able to see the back of the tablet.
- Hold tablet and be ready to continue onto the next steps.
Start by holding your Toshiba tablet faced up.
Flip the tablet from left to right so that you are able to see the back of the tablet.
Hold tablet and be ready to continue onto the next steps.
1024
Step 2
- Insert a plastic opening tool in the back case of the tablet to free the clips.
- Begin to pull the tool up slightly and work your way around the tablet to free all the clips.
- Using a metal opening tool as shown in the photos has the potential to damage your device.
Insert a plastic opening tool in the back case of the tablet to free the clips.
Begin to pull the tool up slightly and work your way around the tablet to free all the clips.
Using a metal opening tool as shown in the photos has the potential to damage your device.
Step 3
- Hold back lid with your right hand and keep lifting to remove the back lid.
- Pull the back lid from right to left and top to bottom.
- Once you disconnect the back lid, place lid aside.
Hold back lid with your right hand and keep lifting to remove the back lid.
Pull the back lid from right to left and top to bottom.
Once you disconnect the back lid, place lid aside.
Step 4
- Use plastic spudger to remove the attached battery wires by pushing the plastic wire holder from right to left on top and bottom part of plastic holder.
Use plastic spudger to remove the attached battery wires by pushing the plastic wire holder from right to left on top and bottom part of plastic holder.
Step 5
- Start by using your left hand on the top left corner on the battery.
- Then, begin to lift and work your way around the battery.
Start by using your left hand on the top left corner on the battery.
Then, begin to lift and work your way around the battery.
Step 6
- Remove the battery from the compartment.
Remove the battery from the compartment.
Step 7
Motherboard
- Once you take off the back case and battery, set tablet screen faced down.
- Unscrew the 11 screws shown in the markups with a Phillips #00 screwdriver.
- BE AWARE: Screws are extremely small.
Once you take off the back case and battery, set tablet screen faced down.
Unscrew the 11 screws shown in the markups with a Phillips #00 screwdriver.
BE AWARE: Screws are extremely small.
Step 8
- Before taking off motherboard, grab tweezers to peel off tape on the two ribbons marked on the picture.
- Once tape is removed, use the same tweezers to carefully pull the ribbons downwards to disconnect from motherboard.
Before taking off motherboard, grab tweezers to peel off tape on the two ribbons marked on the picture.
Once tape is removed, use the same tweezers to carefully pull the ribbons downwards to disconnect from motherboard.
Step 9
- On the top left corner, pull the black compartment carefully upwards.
- This component still has wires attached, so be careful not to sever the wires as you remove it.
On the top left corner, pull the black compartment carefully upwards.
This component still has wires attached, so be careful not to sever the wires as you remove it.
Step 10
- Once black compartment is off, you will be prepared to disconnect motherboard.
- Carefully lift motherboard upwards with the black compartment.
Once black compartment is off, you will be prepared to disconnect motherboard.
Carefully lift motherboard upwards with the black compartment.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Ericka Castillo
Member since: 04/08/2019
303 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
Eastern Washington University, Team S1-G4, Rowley Spring 2019
Member of Eastern Washington University, Team S1-G4, Rowley Spring 2019
EWU-ROWLEY-S19S1G4
4 Members
3 Guides authored
