Toshiba A1304T Keypad Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          20 - 30 minutes            

Sections

2

• Back panel
• 3 steps
• Keypad
• 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

• BackToshiba A1304T

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back panel               

• Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

1024

Step 2

• With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
• The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.

The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

Step 3

• If needed, use the flathead screwdriver to gently pry the panel from the phone.
• Using your fingers, lift the panel from the device.

If needed, use the flathead screwdriver to gently pry the panel from the phone.

Using your fingers, lift the panel from the device.

Step 4

              Keypad               

• Use your fingers to detach the ribbon wire located on the top of the logic board, as shown.

Use your fingers to detach the ribbon wire located on the top of the logic board, as shown.

Step 5

• Use a flathead screwdriver to gently pry the logic board and keypad from the device.

Use a flathead screwdriver to gently pry the logic board and keypad from the device.

Step 6

• Peel the keypad from the logic board using your thumb.

Peel the keypad from the logic board using your thumb.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 

                    Christopher                     

Member since: 04/22/2010

90 Reputation

                                      8 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       Cal Poly, Team 16-6, Maness Spring 2010                        

                                                  Member of Cal Poly, Team 16-6, Maness Spring 2010 



                    CPSU-MANESS-S10S16G6                     


                                            4 Members                     


                                            16 Guides authored