Difficulty
Moderate
Steps
12
Time Required
10 - 20 minutes
Sections
2
- Toro Cement Mixer 68009HD 2018 Safety Precautions
- 5 steps
- Tub
- 7 steps
Flags
0
BackToro Cement Mixer 68009HD (2018)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Warning: The tub is extremely heavy and requires at least two people to lift it. Be sure to practice safe lifting techniques.
What you need
Step 1
Safety precautions
- Before you begin, press the engine-stop switch to turn off the engine.
Before you begin, press the engine-stop switch to turn off the engine.
1024
Step 2
- Unlatch the three rubber straps securing the cowl.
Unlatch the three rubber straps securing the cowl.
Step 3
- Swing the cowl up until it rests securely on the frame.
Swing the cowl up until it rests securely on the frame.
Step 4
- Slide the fuel cutoff lever to the left to cut the fuel supply to the engine.
Slide the fuel cutoff lever to the left to cut the fuel supply to the engine.
Step 5
- Grab the plastic housing at the end of the spark plug wire.
- Pull firmly to disconnect the wire from the spark plug.
Grab the plastic housing at the end of the spark plug wire.
Pull firmly to disconnect the wire from the spark plug.
Step 6
Remove the tub
- Pull up on the brake lever to disengage the brake.
Pull up on the brake lever to disengage the brake.
Step 7
- Rotate the tub until the yoke and dish assembly sit directly below the tub.
Rotate the tub until the yoke and dish assembly sit directly below the tub.
Step 8
- Push down on the brake lever to re-engage the brake.
- Make sure that the brake is fully engaged.
Push down on the brake lever to re-engage the brake.
Make sure that the brake is fully engaged.
Step 9
- Use a 3/4 inch socket to remove the six nuts securing the tub to the dish.
Use a 3/4 inch socket to remove the six nuts securing the tub to the dish.
Step 10
- Remove the six drum clamp plates from the tub mounting points.
Remove the six drum clamp plates from the tub mounting points.
Step 11
- Lift the tub up slightly by the gear ring to loosen the tub from the dish.
Lift the tub up slightly by the gear ring to loosen the tub from the dish.
Step 12
- The tub is extremely heavy and requires at least two people to lift it. Be sure to practice safe lifting techniques.
- Lift the tub straight up from the dish and remove it from the device.
The tub is extremely heavy and requires at least two people to lift it. Be sure to practice safe lifting techniques.
Lift the tub straight up from the dish and remove it from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Arthur Shi
Member since: 01/03/2018
211,874 Reputation
442 Guides authored
Badges:
46
+43 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored