Difficulty
Easy
Steps
3
Time Required
4 minutes
Sections
1
- Top Cover
- 3 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDigMedia MusicStore
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Remove screws
- Remove six Philips #2 screws from the bottom of the case.
- REASSEMBLY CAUTION: To prevent thread stripping during reassembly, turn screws backwards slowly until you feel the screw thread drop into the original plastic thread, and only then, tighten screw normally but lightly - you’re working with 20+ year-old plastics.
Remove six Philips #2 screws from the bottom of the case.
REASSEMBLY CAUTION: To prevent thread stripping during reassembly, turn screws backwards slowly until you feel the screw thread drop into the original plastic thread, and only then, tighten screw normally but lightly - you’re working with 20+ year-old plastics.
1024
Step 2
Disconnect top cover ribbon cable
- Carefully fold the top and bottom open, revealing a ribbon cable connecting the two halves.
- Unlock and disconnect the ribbon cable. Unlock by pulling the lock lever evenly on both sides, parallel to the board surface (not lift/pivot), in the direction of the ribbon cable.
- When this ZIF (Zero Insertion Force) connector is properly unlocked, the ribbon cable should just fall right out of the socket (no need to pull with any strength).
Carefully fold the top and bottom open, revealing a ribbon cable connecting the two halves.
Unlock and disconnect the ribbon cable. Unlock by pulling the lock lever evenly on both sides, parallel to the board surface (not lift/pivot), in the direction of the ribbon cable.
When this ZIF (Zero Insertion Force) connector is properly unlocked, the ribbon cable should just fall right out of the socket (no need to pull with any strength).
Step 3
Remove RF shield
- Simply lift the RF shield off the unit.
- When reinstalling, take note of the 6 fork-like interlocking clips around the edge of the shield, which should engage with the original positions.
Simply lift the RF shield off the unit.
When reinstalling, take note of the 6 fork-like interlocking clips around the edge of the shield, which should engage with the original positions.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Matt Falcon
Member since: 05/09/2015
1,049 Reputation
13 Guides authored
Badges:
13
+10 more badges