Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
1
- Toolcraft ST-50D solder station Disassembly
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackToolcraft ST-50D solder station
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
So looks the solder station.
- I think you can disassembly other models of Toolcraft ST solder stations 50/80/100 analog or digital the same way.
I think you can disassembly other models of Toolcraft ST solder stations 50/80/100 analog or digital the same way.
1024
Step 2
Put the solder station on the back.
- There are two holes with screws on the bottom side (green circles on the picture) and the 2-nd pair of screws is under the two rubbery “legs” (red circles).
There are two holes with screws on the bottom side (green circles on the picture) and the 2-nd pair of screws is under the two rubbery “legs” (red circles).
Step 3
Unglue the two "legs"...
- … by nails or by flat screwdriver and you will see the second pair of holes with screws.
… by nails or by flat screwdriver and you will see the second pair of holes with screws.
Step 4
Unscrew the screws ...
- … by Phillips #1 screwdriver and you can open the body of the solder station.
… by Phillips #1 screwdriver and you can open the body of the solder station.
Step 5
- The cables connected to switch: ON is Up , from inside: 1) RED + BLUE 2) BROWN
The cables connected to switch: ON is Up , from inside: 1) RED + BLUE 2) BROWN
Step 6
- From inside.
From inside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Martin Kubica
Member since: 05/13/2016
784 Reputation
1 Guide authored
Badges:
10
+7 more badges
omanoman - Dec 11, 2019
Reply
Hi! Unfortunately, I have stupidly pulled off the contact sockets of the switch when disassembling my station. But I did not notice how they were originally connected. Could you please take a look and maybe take a picture of how the contacts are connected to the switch? I thank you in advance.
Martin Kubica - Dec 16, 2019
Reply
Hi.
So I added a picture of cables connected to the switch. ON position of the switch is Up, the cables are from inside of the solder station.
Martin Kubica
Michael Telatynski - Feb 13, 2020
Reply
Hello Martin, really appreciate your guide but do you have a photo of the back of the board with all the connections? I took it apart but did not take note of which connector the White, Blue and Red/Black wires went to. Its not clear on the photos above, would be hugely appreciated. Thanks!
Павел Vor - Oct 13, 2021
Reply
здравствуйте помагите найти на нее нагревательный элементяя даже не знаю какой должен быть спасибо