Difficulty
Easy
Steps
5
Time Required
5 - 10 minutes
Sections
1
- Retention Pin
- 5 steps
Flags
0
Back2016 Toyota Tacoma Tonneau Trifold Bed Cover
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Retention Pin
- Locate the two screws on the retaining latch.
- Use an Allen Wrench to loosen the screws.
- The screws are tight and may require significant force.
Locate the two screws on the retaining latch.
Use an Allen Wrench to loosen the screws.
The screws are tight and may require significant force.
1024
Step 2
- Continue loosening the screws until they are both loose enough to remove by hand.
Continue loosening the screws until they are both loose enough to remove by hand.
Step 3
- Grab both screws and pull them straight out.
- Line up the holes on the replacement latch, then insert the new screws.
Grab both screws and pull them straight out.
Line up the holes on the replacement latch, then insert the new screws.
Step 4
- Hand tighten both of the bolts onto the new latch.
Hand tighten both of the bolts onto the new latch.
Step 5
- Tighten both screws evenly until the latch is held firmly in place.
- Do not over tighten - you could break the Allen Wrench or strip the screws!
Tighten both screws evenly until the latch is held firmly in place.
Do not over tighten - you could break the Allen Wrench or strip the screws!
To reassemble your device, follow these instructions in order.
Cancel: I did not complete this guide.
Author
with 8 other contributors
Christopher King
Member since: 01/16/2018
139 Reputation
1 Guide authored
Badges:
2
Team
USF Sarasota-Manatee, Team S1-G1, Stewart Spring 2018
Member of USF Sarasota-Manatee, Team S1-G1, Stewart Spring 2018
USFSM-STEWART-S18S1G1
15 Members
25 Guides authored