Tomtom One Screen Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Screen
8 steps

Flags

BackTomTom ONE
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

1024

Step 2

Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

Step 3

Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

Step 4

Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

Step 5

Next, you must remove the motherboard from the front screen.
Use a Torx T-7 screwdriver to unscrew the two screws.

Next, you must remove the motherboard from the front screen.

Use a Torx T-7 screwdriver to unscrew the two screws.

Step 6

Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two.
To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.

Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two.

To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.

Step 7

Once separated, use the spudger to pry around the edges of the outer casing.

Once separated, use the spudger to pry around the edges of the outer casing.

Step 8

Apply pressure with thumbs to remove screen from inner casing.
The screen and front cover are now disconnected.

Apply pressure with thumbs to remove screen from inner casing.

The screen and front cover are now disconnected.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 6 other contributors

                    Alex Cauvy

Member since: 04/18/2010

41 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 7-7, Maness Spring 2010                        

                                                  Member of Cal Poly, Team 7-7, Maness Spring 2010 



                    CPSU-MANESS-S10S7G7                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team