Difficulty

Moderate

Steps

7

Time Required

                          20 minutes

Sections

1

  • Battery
  • 7 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackTimex T73751 Clip On Watch

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Introduction -- The Front
  • The front of the watch. Of course the battery is in the back.
  • The button on the left is used to rotate the watch within the clip. The button does not release the watch from the clip.

The front of the watch. Of course the battery is in the back.

The button on the left is used to rotate the watch within the clip. The button does not release the watch from the clip.

1024

Step 2

  • Remove the four (4) screws on the rear of the watch. Note the battery number (CR2025) printed on the back of the watch

Remove the four (4) screws on the rear of the watch. Note the battery number (CR2025) printed on the back of the watch

Step 3

              Remove the back cover
  • You will find a rubber cover held down by 6 small metal tabs.
  • Note - the tab circled in orange was bent in a way that the tab could not be unbent. I don’t know if that is on purpose.

You will find a rubber cover held down by 6 small metal tabs.

Note - the tab circled in orange was bent in a way that the tab could not be unbent. I don’t know if that is on purpose.

Step 4

              Remove the rubber gasket
  • The tabs are now bent upward in order to release the rubber gasket. Note that the tab circled in orange was not unbent.

The tabs are now bent upward in order to release the rubber gasket. Note that the tab circled in orange was not unbent.

Step 5

              Remove the battery cover
  • The upper screw is longer than the lower screw. The upper screw tab has an extra tab.

The upper screw is longer than the lower screw. The upper screw tab has an extra tab.

Step 6

              Remove the battery and cover
  • Two screws hold down the battery cover. The screw in the side with a tab is slightly longer than the other side.

Two screws hold down the battery cover. The screw in the side with a tab is slightly longer than the other side.

Step 7

              Separate battery and battery holder
  • Peel the battery holder off of the CR2025 battery.
  • Note the message on the cover: After battery insertion short AC pad and battery (+) to reset. Note the small arrow on the lower left.
  • The top of the battery is (+).

Peel the battery holder off of the CR2025 battery.

Note the message on the cover: After battery insertion short AC pad and battery (+) to reset. Note the small arrow on the lower left.

The top of the battery is (+).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    DuaneMurphy1

385 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Loquacious One - Sep 15, 2021

Reply

Thank you Duane! I had taken the back off but didn’t realize the battery was under a sticker. It was there the whole time after all. I’ve had this watch for years and never got this done until now so it’s nice to see it running again. Great directions on your part. I used to do all the battery replacements and band installs/ link removal at our department store as a young woman but it’s been awhile and I’m a bit rusty at this now.