Difficulty
Easy
Steps
6
Time Required
10 minutes
Sections
2
- Back Plate
- 3 steps
- Toggle Switch
- 3 steps
Flags
0
BackThe Beatles Rock Band Hofner Bass
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Plate
- Flip the bass onto its backside, so that the strummer is facing the table and the battery compartment is facing you.
- Use a J1 Phillips head screwdriver to remove ten 5mm short screws.
- Use a J1 Phillips head screwdriver to remove four 5mm long screws.
Flip the bass onto its backside, so that the strummer is facing the table and the battery compartment is facing you.
Use a J1 Phillips head screwdriver to remove ten 5mm short screws.
Use a J1 Phillips head screwdriver to remove four 5mm long screws.
1024
Step 2
- Flip the bass to the front, with the strummer and fret buttons facing you.
- Use a J1 Phillips head screwdriver to remove two 10mm silver, short screws.
Flip the bass to the front, with the strummer and fret buttons facing you.
Use a J1 Phillips head screwdriver to remove two 10mm silver, short screws.
Step 3
- Flip the bass on its back again, so that the strummer is facing down and the battery compartment is facing you.
- Pull off the back whole panel so that the bass is now open.
Flip the bass on its back again, so that the strummer is facing down and the battery compartment is facing you.
Pull off the back whole panel so that the bass is now open.
Step 4
Toggle Switch
- With a J1 Phillips screwdriver, remove the six 5mm on the cover.
- Remove the cover.
With a J1 Phillips screwdriver, remove the six 5mm on the cover.
Remove the cover.
Step 5
- Use a J1 Phillips screwdriver to remove the 10mm screw on the toggle switch.
Use a J1 Phillips screwdriver to remove the 10mm screw on the toggle switch.
Step 6
- Remove the wire connecting the toggle switch to the blue circuit board.
- Remove the toggle switch.
Remove the wire connecting the toggle switch to the blue circuit board.
Remove the toggle switch.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Jacob
Member since: 01/25/2017
601 Reputation
6 Guides authored
Badges:
5
+2 more badges
Team
Cal Poly, Team 8-4, Banghart Winter 2017
Member of Cal Poly, Team 8-4, Banghart Winter 2017
CPSU-BANGHART-W17S8G4
3 Members
6 Guides authored