The Beatles Rock Band Hofner Bass Strummer Bar Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 minutes            

Sections

2

• Back Plate
• 3 steps
• Strummer Bar
• 2 steps

Flags

0

• BackThe Beatles Rock Band Hofner Bass

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Plate               

• Flip the bass onto its backside, so that the strummer is facing the table and the battery compartment is facing you.
• Use a J1 Phillips head screwdriver to remove ten 5mm short screws.
• Use a J1 Phillips head screwdriver to remove four 5mm long screws.

Flip the bass onto its backside, so that the strummer is facing the table and the battery compartment is facing you.

Use a J1 Phillips head screwdriver to remove ten 5mm short screws.

Use a J1 Phillips head screwdriver to remove four 5mm long screws.

1024

Step 2

• Flip the bass to the front, with the strummer and fret buttons facing you.
• Use a J1 Phillips head screwdriver to remove two 10mm silver, short screws.

Flip the bass to the front, with the strummer and fret buttons facing you.

Use a J1 Phillips head screwdriver to remove two 10mm silver, short screws.

Step 3

• Flip the bass on its back again, so that the strummer is facing down and the battery compartment is facing you.
• Pull off the back whole panel so that the bass is now open.

Flip the bass on its back again, so that the strummer is facing down and the battery compartment is facing you.

Pull off the back whole panel so that the bass is now open.

Step 4

              Strummer Bar               

• Use a J1 Phillips head screwdriver to remove the four 10mm screws at the corners of the black casing.

Use a J1 Phillips head screwdriver to remove the four 10mm screws at the corners of the black casing.

Step 5

• Remove the connection from the board, so that the strummer is no longer connected.
• Carefully take the strummer out of the guitar, now that it is no longer connected.
• Now the strummer is completely removed.

Remove the connection from the board, so that the strummer is no longer connected.

Carefully take the strummer out of the guitar, now that it is no longer connected.

Now the strummer is completely removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Jacob                     

Member since: 01/25/2017

601 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Cal Poly, Team 8-4, Banghart Winter 2017                        

                                                  Member of Cal Poly, Team 8-4, Banghart Winter 2017 



                    CPSU-BANGHART-W17S8G4                     


                                            3 Members                     


                                            6 Guides authored                     

Peter Grav - Jan 11, 2020

Reply

How/where do I purshase a new strummer bar?