Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Drum Pad
- 4 steps
Flags
0
BackThe Beatles Rock Band Drum Set
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Drum Pad
- Pry the drum pad off of the drum set.
- This will take significant force, but the rubber on the drum pad can withstand the force.
Pry the drum pad off of the drum set.
This will take significant force, but the rubber on the drum pad can withstand the force.
1024
Step 2
- Remove the small wire clip shown in the picture.
- If this wire is already disconnected, that is most likely the cause for the drum pad not working.
Remove the small wire clip shown in the picture.
If this wire is already disconnected, that is most likely the cause for the drum pad not working.
Step 3
- Remove the four Phillips size J0 screws supporting the hit sensor.
- There is a small plastic disk and a spring in the support; be sure not to lose it.
Remove the four Phillips size J0 screws supporting the hit sensor.
There is a small plastic disk and a spring in the support; be sure not to lose it.
Step 4
- The sensor can be peeled off of the drum pad.
The sensor can be peeled off of the drum pad.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Zach Richter
Member since: 01/24/2017
525 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 13-3, Banghart Winter 2017
Member of Cal Poly, Team 13-3, Banghart Winter 2017
CPSU-BANGHART-W17S13G3
4 Members
5 Guides authored
Barry Howard - Jan 17, 2021
Reply
Where can you buy replacement sensor?