Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

1

  • TGL 57-1022 Disassembly
  • 6 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackTGL 57-1022

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              TGL 57-1022 Disassembly
  • Unscrew the black end cap

Unscrew the black end cap

1024

Step 2

  • Untie the cord securing the cap of the plug.
  • Use the screwdriver to push the circlip out of it’s slot and remove the outer ring assembly

Untie the cord securing the cap of the plug.

Use the screwdriver to push the circlip out of it’s slot and remove the outer ring assembly

Step 3

  • Using your thumb prise out the rubber ring from the top of the plug.
  • If the ring does not release you can use a screwdriver to gently push it out.
  • The retaining ring should now be visible, note the four slots in the ring.

Using your thumb prise out the rubber ring from the top of the plug.

If the ring does not release you can use a screwdriver to gently push it out.

The retaining ring should now be visible, note the four slots in the ring.

Step 4

  • Using the long nose pliers remove the retaining ring by unscrewing it counter-clockwise from the inner assembly.

Using the long nose pliers remove the retaining ring by unscrewing it counter-clockwise from the inner assembly.

Step 5

  • Push the cable into the inner assembly until the connector is fully exposed from the assembly.
  • From the plug end, gently push the cable out to expose the two metal rings and rubber water-proofing ring.

Push the cable into the inner assembly until the connector is fully exposed from the assembly.

From the plug end, gently push the cable out to expose the two metal rings and rubber water-proofing ring.

Step 6

  • Using the screwdriver release the clip securing the cable to the plug housing.
  • Unscrew the leads from the plug terminals.

Using the screwdriver release the clip securing the cable to the plug housing.

Unscrew the leads from the plug terminals.

To reassemble your device, follow these instructions in reverse order. When placing back the grey rubber ring on top gently push it in, you can use the screwdriver to gently! ease it back in.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Sander van Vliet

Member since: 01/22/2017

131 Reputation

                                      1 Guide authored                  



                       Badges:
                       2