Difficulty
Moderate
Steps
5
Time Required
5 - 10 minutes
Sections
1
- Printer Unit
- 5 steps
Flags
0
BackTexas Instruments TI-5130
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Printer Unit
- Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.
Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.
1024
Step 2
- Flip the calculator back over and remove the top cover.
Flip the calculator back over and remove the top cover.
Step 3
- Disconnect the printing unit from the motherboard by pulling up on the connector – located in the bottom left of the motherboard.
Disconnect the printing unit from the motherboard by pulling up on the connector – located in the bottom left of the motherboard.
Step 4
- Remove the ink cartridge by pushing the tab back then lifting it out to gain access to the screw that holds the printer in place.
Remove the ink cartridge by pushing the tab back then lifting it out to gain access to the screw that holds the printer in place.
Step 5
- Using a PH1 screwdriver remove the 10mm screw that holds down the printer unit.
- Remove the printer unit by lifting it up.
Using a PH1 screwdriver remove the 10mm screw that holds down the printer unit.
Remove the printer unit by lifting it up.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 1 other contributor
Shannon Perkins
Member since: 09/17/2015
625 Reputation
3 Guides authored
Badges:
10
+7 more badges
Team
USF Sarasota-Manatee, Team 1-2, Stewart Fall 2015
Member of USF Sarasota-Manatee, Team 1-2, Stewart Fall 2015
USFSM-STEWART-F15S1G2
5 Members
16 Guides authored
Tino ullrich - Mar 4, 2017
Reply
wehre did you buy the replacement printer