Difficulty
Difficult
Steps
7
Time Required
15 - 45 minutes
Sections
1
- Power Cord
- 7 steps
Flags
0
BackTexas Instruments TI-5130
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.
Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.
1024
Step 2
- Remove the top cover.
- Gently pull up on the power cord to remove it from the back cover.
Remove the top cover.
Gently pull up on the power cord to remove it from the back cover.
Step 3
- This step is optional; however it makes it easier to work.
- Using a PH1 screwdriver remove the two 10mm screws that hold down the transformer.
- Gently remove the transformer.
- Make sure that the calculator is not plugged in.
This step is optional; however it makes it easier to work.
Using a PH1 screwdriver remove the two 10mm screws that hold down the transformer.
Gently remove the transformer.
Make sure that the calculator is not plugged in.
Step 4
- Use a wire cutter to cut off the white cap and expose the wires. Try to cut close to the tip of the white cap - to leave as much wire as possible.
- Note that there are 2 sets of wires connected to the power cord. Do each set of wires separately.
Use a wire cutter to cut off the white cap and expose the wires. Try to cut close to the tip of the white cap - to leave as much wire as possible.
Note that there are 2 sets of wires connected to the power cord. Do each set of wires separately.
Step 5
- Use a wire stripper to remove 1/2” of the protective covering on each of the wires.
Use a wire stripper to remove 1/2” of the protective covering on each of the wires.
Step 6
- Twist the exposed section of the 2 wires together.
- Twist a new cap over the exposed wires. Make sure that the cap covers all of the exposed wire.
- Repeat steps 4-6 for the second set of wires.
Twist the exposed section of the 2 wires together.
Twist a new cap over the exposed wires. Make sure that the cap covers all of the exposed wire.
Repeat steps 4-6 for the second set of wires.
Step 7
- Replace the transformer and ensure that the new wire caps fit in the space shown.
- Plug in the new power cord and test the calculator before replacing the top cover.
Replace the transformer and ensure that the new wire caps fit in the space shown.
Plug in the new power cord and test the calculator before replacing the top cover.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Shannon Perkins
Member since: 09/17/2015
625 Reputation
3 Guides authored
Badges:
10
+7 more badges
Team
USF Sarasota-Manatee, Team 1-2, Stewart Fall 2015
Member of USF Sarasota-Manatee, Team 1-2, Stewart Fall 2015
USFSM-STEWART-F15S1G2
5 Members
16 Guides authored