Difficulty
Moderate
Steps
3
Time Required
30 minutes
Sections
2
- Opening the Tesco hudl2 case
- 2 steps
- Charge port
- 1 step
Flags
1
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackTesco hudl2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Video Overview
Step 1
Open the case
- Take your time!
- Use a guitar pick, although some have successfully used a fingernail. Don’t use a screwdriver as you will damage the case.
- Start at one corner and carefully insert your tool, working it along the seam until you hear a click and the case starts to come apart.
- Carry on working your way around the case. Be very careful near the buttons.
- Eventually the rear case will come away. There aren’t any wires attached to the rear case, it just lifts off.
- When it’s time to reassemble, clip the rear cover back on carefully, making sure to fit the side with the buttons first and being careful to ensure they are positioned correctly.
Take your time!
Use a guitar pick, although some have successfully used a fingernail. Don’t use a screwdriver as you will damage the case.
Start at one corner and carefully insert your tool, working it along the seam until you hear a click and the case starts to come apart.
Carry on working your way around the case. Be very careful near the buttons.
Eventually the rear case will come away. There aren’t any wires attached to the rear case, it just lifts off.
When it’s time to reassemble, clip the rear cover back on carefully, making sure to fit the side with the buttons first and being careful to ensure they are positioned correctly.
1024
Step 2
- This is what you will see once the rear case is removed.
This is what you will see once the rear case is removed.
Step 3
Replace the charging port
- Carefully peel off the black sticky tape and set it aside.
- Don’t damage the twisted wire leading to the speaker.
- Unscrew the two screws holding the port in place.
- Remove the two pin speaker plug by moving it gently from side to side until it comes out of its socket.
- Use a spudger to flip open the latch and then withdraw the flat cable.
- Lift out the board and replace with a new one. Reattach the black sticky tape.
Carefully peel off the black sticky tape and set it aside.
Don’t damage the twisted wire leading to the speaker.
Unscrew the two screws holding the port in place.
Remove the two pin speaker plug by moving it gently from side to side until it comes out of its socket.
Use a spudger to flip open the latch and then withdraw the flat cable.
Lift out the board and replace with a new one. Reattach the black sticky tape.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Tim
Member since: 08/31/2010
1,378 Reputation
10 Guides authored
Badges:
21
+18 more badges