Tengda S5 Plus Rear Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Back Panel
2 steps
Battery
1 step
Rear Camera
4 steps

Flags

BackTengda S5+
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Place the phone screen-side down.

Place the phone screen-side down.

1024

Step 2

Using your fingernail or any prying tool (we used the Metal Spudger), begin to pry away the back panel starting at the bottom of the phone.
Continue to work your way around the phone counterclockwise until you can pull the back cover off.

Using your fingernail or any prying tool (we used the Metal Spudger), begin to pry away the back panel starting at the bottom of the phone.

Continue to work your way around the phone counterclockwise until you can pull the back cover off.

Step 3

              Battery

Remove the battery by placing your thumb in the slot, pushing the battery up and pulling it out.

Remove the battery by placing your thumb in the slot, pushing the battery up and pulling it out.

Step 4

              Rear Camera

Unscrew the twelve 3 mm screws from the back panel using a Phillips #00 screwdriver.
Keep these screws in a safe place. They are very small and easy to lose.

Unscrew the twelve 3 mm screws from the back panel using a Phillips #00 screwdriver.

Keep these screws in a safe place. They are very small and easy to lose.

Step 5

Using the plastic opening tool, create space between the front screen and the metal casing.
Once the screen is separated from the back panel, pull the two pieces apart.

Using the plastic opening tool, create space between the front screen and the metal casing.

Once the screen is separated from the back panel, pull the two pieces apart.

Step 6

Place the phone facing screen down.
Using the plastic prying tool, gently disconnect the black connector cable.
The connector cable should easy snap out with little force.

Place the phone facing screen down.

Using the plastic prying tool, gently disconnect the black connector cable.

The connector cable should easy snap out with little force.

Step 7

Using the plastic prying tool, pry the camera from the tape holding it in place.
Be careful not to rip the tape.

Using the plastic prying tool, pry the camera from the tape holding it in place.

Be careful not to rip the tape.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Jholmesford

Member since: 04/21/2015

164 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team 14-9, Amido Spring 2015                        

                                                  Member of Cal Poly, Team 14-9, Amido Spring 2015 



                    CPSU-AMIDO-S15S14G9                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team