Telstra Dave 4G Zte T83 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

• Battery
• 3 steps

Flags

2

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackTelstra Dave 4G ZTE T83

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Outer Case               

• Remove the four H2 screws from the back of the phone. Do not lose the black rubber rings on the screws.
• Remove the two H2 screws, on either side of the phone. Do not lose the red seal that are on the screws.
• Using a prying tool work off the back of the case. Ensuring not to lose the port covers. Be careful to note the position of connector covers. Have the tabs at the end of the connectors in place before clipping the phone completely back together.

Remove the four H2 screws from the back of the phone. Do not lose the black rubber rings on the screws.

Remove the two H2 screws, on either side of the phone. Do not lose the red seal that are on the screws.

Using a prying tool work off the back of the case. Ensuring not to lose the port covers. Be careful to note the position of connector covers. Have the tabs at the end of the connectors in place before clipping the phone completely back together.

1024

Step 2

              Battery Connector Cover               

• Remove the two black Philips head screws from the battery connector cover.
• Lift the battery cover away from the logic board

Remove the two black Philips head screws from the battery connector cover.

Lift the battery cover away from the logic board

Step 3

              Battery               

• Disconnect the battery connector from the logic board. Do so by inserting a flat tool under the wires on the indicated side and wedging it up off the logic board.
• Then remove the double sided tape using the blue tabs provided. Simply grab a tab and pull until it comes out tweezers are really good for beginning the process.
• These pull tabs will need to be replaced with double sided tape on reassembly.

Disconnect the battery connector from the logic board. Do so by inserting a flat tool under the wires on the indicated side and wedging it up off the logic board.

Then remove the double sided tape using the blue tabs provided. Simply grab a tab and pull until it comes out tweezers are really good for beginning the process.

These pull tabs will need to be replaced with double sided tape on reassembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Ryan                     

Member since: 08/19/2015

1,414 Reputation

                                      14 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges                           

Neil STRONG - Apr 3, 2018

Reply

How similar is the process for the Telstra Tough Max ZTE T84?