Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

2

  • Back Cover
  • 3 steps
  • Rubber Feet
  • 3 steps

Flags

0

  • BackTeenage Engineering OP-Z

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.
  • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

1024

Step 2

  • When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).
  • If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

Step 3

  • Remove the bottom plate including the rubber feet.

Remove the bottom plate including the rubber feet.

Step 4

              Rubber Feet
  • Remove the four Phillips #0 screws from the back of the rubber feet.

Remove the four Phillips #0 screws from the back of the rubber feet.

Step 5

  • Separate the front and rear part of the rubber feet from the back cover.

Separate the front and rear part of the rubber feet from the back cover.

Step 6

  • When reassembling make sure to correctly align the front and rear part of the rubber feet. The notch and grove should interlock and fit into the cutout of the back cover.

When reassembling make sure to correctly align the front and rear part of the rubber feet. The notch and grove should interlock and fit into the cutout of the back cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Tobias Isakeit

Member since: 03/31/2014

105,397 Reputation

                                      184 Guides authored                  



                       Badges:
                       46







                                                        +43 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored