Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
1
- Battery
- 6 steps
Flags
0
BackTagital T10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Always make sure your device is completely powered off before performing repairs.
- Remove the two 4 mm Phillips head screws at the top of the device.
Always make sure your device is completely powered off before performing repairs.
Remove the two 4 mm Phillips head screws at the top of the device.
1024
Step 2
- Carefully remove the back cover by using a plastic opening tool, moving all the way around the perimeter of the tablet.
- Set the back cover aside.
- The speakers are attached to the inside back cover, and are connected by wires to the motherboard of the tablet. Be careful not to rip these free when removing the back.
Carefully remove the back cover by using a plastic opening tool, moving all the way around the perimeter of the tablet.
Set the back cover aside.
The speakers are attached to the inside back cover, and are connected by wires to the motherboard of the tablet. Be careful not to rip these free when removing the back.
Step 3
- Locate the red and black wires that connect the battery to the motherboard.
- Carefully peel away the tape that keeps the wires secured to the back of the display screen.
Locate the red and black wires that connect the battery to the motherboard.
Carefully peel away the tape that keeps the wires secured to the back of the display screen.
Step 4
- Be sure to use tweezers when near the soldering iron because it is hot.
- Soften the old solder by heating it with the soldering tool, so that the wires can be removed with tweezers.
Be sure to use tweezers when near the soldering iron because it is hot.
Soften the old solder by heating it with the soldering tool, so that the wires can be removed with tweezers.
Step 5
- Heat up the battery with the iOpener Heat tool in order to soften the adhesive that keeps the battery in place.
- The iOpener Heat tool gets very hot, so be careful that you don’t burn yourself.
Heat up the battery with the iOpener Heat tool in order to soften the adhesive that keeps the battery in place.
The iOpener Heat tool gets very hot, so be careful that you don’t burn yourself.
Step 6
- Remove the battery from the device with the plastic opening tool.
- It may be difficult to remove so try reheating the iOpener and don’t be afraid to use a good amount of force.
Remove the battery from the device with the plastic opening tool.
It may be difficult to remove so try reheating the iOpener and don’t be afraid to use a good amount of force.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Cody D'Amato
Member since: 09/26/2016
303 Reputation
2 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 14-5, Eyestone Fall 2016
Member of USF Tampa, Team 14-5, Eyestone Fall 2016
USFT-EYESTONE-F16S14G5
4 Members
10 Guides authored