Difficulty
Moderate
Steps
8
Time Required
20 - 35 minutes
Sections
1
- Ultrasonic Plate
- 8 steps
Flags
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackHousehold Item
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before beginning the repair, be sure to unplug the power adapter.
What you need
Step 1
Ultrasonic Plate
- First, make sure the water tank inside the diffuser is completely dry to avoid any water from contacting the internal components.
- Make sure the diffuser is disconnected from the power source to avoid electrical hazards.
First, make sure the water tank inside the diffuser is completely dry to avoid any water from contacting the internal components.
Make sure the diffuser is disconnected from the power source to avoid electrical hazards.
1024
Step 2
- With a Phillips #1 screwdriver, remove the three 10 mm screws on the bottom of the diffuser.
With a Phillips #1 screwdriver, remove the three 10 mm screws on the bottom of the diffuser.
Step 3
- Lift the water tank while holding the base of the diffuser.
- Disconnect the three cables form the board.
- Make sure when reassembling the diffuser to plug in each cable to its assigned port.
Lift the water tank while holding the base of the diffuser.
Disconnect the three cables form the board.
Make sure when reassembling the diffuser to plug in each cable to its assigned port.
Step 4
- To separate the board from the water tank, unscrew the three Phillips #1 10 mm screws securing the board.
To separate the board from the water tank, unscrew the three Phillips #1 10 mm screws securing the board.
Step 5
- With a Phillips #0 screwdriver, remove the three 7 mm screws from the ultrasonic sensor cover.
- Remove the cover to expose the ultrasonic sensor.
With a Phillips #0 screwdriver, remove the three 7 mm screws from the ultrasonic sensor cover.
Remove the cover to expose the ultrasonic sensor.
Step 6
- Detach the ultrasonic sensor from the water tank.
- Detach the ultrasonic sensor connector from the board.
Detach the ultrasonic sensor from the water tank.
Detach the ultrasonic sensor connector from the board.
Step 7
- Remove the rubber cover from the ultrasonic plate.
Remove the rubber cover from the ultrasonic plate.
Step 8
- Now you can replace the ultrasonic plate of your diffuser.
Now you can replace the ultrasonic plate of your diffuser.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Alejandro R. Calderin Anzueta
Member since: 03/23/2022
157 Reputation
1 Guide authored
Badges:
3
Team
University of Puerto Rico Mayagüez, Team 2-26, Cools Stephens Spring 2022
Member of University of Puerto Rico Mayagüez, Team 2-26, Cools Stephens Spring 2022
UPRM-COOLS STEPHENS-S22S2G26
1 Member
1 Guide authored