Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
1
- Battery
- 7 steps
Flags
0
BackSwiffer SweeperVac
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Unscrew seven 17.95 mm screws on the side of the device.
- Unscrew the 13.87 mm screw.
Unscrew seven 17.95 mm screws on the side of the device.
Unscrew the 13.87 mm screw.
1024
Step 2
- Find the sticker on the back of the device. It may have already been removed.
- If there is a sticker, peel it back from either half of the device.
Find the sticker on the back of the device. It may have already been removed.
If there is a sticker, peel it back from either half of the device.
Step 3
- Firmly, but carefully grip each half of the case and split it open.
Firmly, but carefully grip each half of the case and split it open.
Step 4
- Remove the silver-colored battery cap from the top of the battery.
Remove the silver-colored battery cap from the top of the battery.
Step 5
- Lift the attached battery from the device and place it on the surface.
- Remove the second silver-colored battery cap from the bottom of the interior of the device.
Lift the attached battery from the device and place it on the surface.
Remove the second silver-colored battery cap from the bottom of the interior of the device.
Step 6
- Using the spudger, apply pressure to the lock on the black wire attachment.
- While pressure is being applied to the lock, pull the black wire away from the battery.
Using the spudger, apply pressure to the lock on the black wire attachment.
While pressure is being applied to the lock, pull the black wire away from the battery.
Step 7
- Using the spudger, apply pressure to the lock on the red wire attachment.
- While pressure is being applied to the lock, pull the red wire away from the battery.
- When installing the new battery, you do not need to press down on the locks. Simply plug the wires into the appropriate sockets on the new battery.
Using the spudger, apply pressure to the lock on the red wire attachment.
While pressure is being applied to the lock, pull the red wire away from the battery.
When installing the new battery, you do not need to press down on the locks. Simply plug the wires into the appropriate sockets on the new battery.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
12 other people completed this guide.
Author
with 4 other contributors
Alexander Boesenberg
Member since: 09/22/2014
682 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 10-3, Brown Fall 2014
Member of USF Tampa, Team 10-3, Brown Fall 2014
USFT-BROWN-F14S10G3
3 Members
9 Guides authored
eli3danimator - Jul 23, 2016
Reply
This seems very easy. Will try amd make an update
lillysilbert - Nov 20, 2016
Reply
This was helpful but my swiffer vacuum had a plastic chassis for the battery and I had to remove the circuit board as well to route the wires on my replacement battery as they were not is the same places as the factory battery.
deniseward640 - May 5, 2017
Reply
Where do you purchase the batteries
Where do you purchase the batteries?
Dwight Cooper - Jan 21, 2018
Reply
One place you can get the battery pack as shown is here; https://sweeperbattery.com/. The latest model (easier to install) battery in a case (6 cell - 7.2 volt) is also available from amazon.