Swann Wi Fi Indoor Security Camera Infrared Led Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          1 - 5 minutes            

Sections

2

• Case
• 3 steps
• Infrared LED
• 2 steps

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackSwann Wi-Fi Indoor Security Camera

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

This repair guide requires the handling of electrical components that may be sensitive to ESD (Electrostatic Discharge), so proper ESD protection is also advised.

What you need

Step 1

              Case               

• Use the Phillips #0 to remove the screw located on the back of the camera above the mount.
• Slide the mount out from the bottom of the device.

Use the Phillips #0 to remove the screw located on the back of the camera above the mount.

Slide the mount out from the bottom of the device.

1024

Step 2

• Remove the back of the case by placing a iFixit opening tool underneath the edge of the case and prying it up.

Remove the back of the case by placing a iFixit opening tool underneath the edge of the case and prying it up.

Step 3

• Carefully remove the back of the case without pulling the cables connected to the motherboard and the speaker on the back of the case.

Carefully remove the back of the case without pulling the cables connected to the motherboard and the speaker on the back of the case.

Step 4

              Infrared LED               

• Facing the inside of the front case, unscrew the three 2.0 mm Phillips #0 black screws located on the back of the LED ring.

Facing the inside of the front case, unscrew the three 2.0 mm Phillips #0 black screws located on the back of the LED ring.

Step 5

• Release the clip connection connecting the LED ring to the motherboard.
• Remove the infrared LED assembly.

Release the clip connection connecting the LED ring to the motherboard.

Remove the infrared LED assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Logan Sluder                     

Member since: 09/18/2019

544 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Western Carolina University, Team S1-G4, Virtue Fall 2019                        

                                                  Member of Western Carolina University, Team S1-G4, Virtue Fall 2019 



                    WCU-VIRTUE-F19S1G4                     


                                            4 Members                     


                                            12 Guides authored