Difficulty
Easy
Steps
6
Time Required
10 - 15 minutes
Sections
2
- Back Panels
- 3 steps
- Gyroscope
- 3 steps
Flags
0
BackSwagTron T1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panels
- Ensure that the SwagTron is off.
- Turn the SwagTron upside down to see the underside.
Ensure that the SwagTron is off.
Turn the SwagTron upside down to see the underside.
1024
Step 2
- Unscrew the eighteen 10mm screws that secure the back panels using a Phillips #2 screwdriver.
- The screws are tightly in place. It will take effort to screw them out.
- The panel is still attached to the SwagTron by wires that go to the motherboard.
- Carefully lift the panels off
Unscrew the eighteen 10mm screws that secure the back panels using a Phillips #2 screwdriver.
The screws are tightly in place. It will take effort to screw them out.
The panel is still attached to the SwagTron by wires that go to the motherboard.
Carefully lift the panels off
Step 3
- Follow the wires from the panels to the motherboard.
- You may need to cut any zip ties that are holding the wires together.
- There is one connection on the battery side and three on the other side that must be removed.
- These connections may be difficult to remove. Try to securely press the connection and pull firmly.
- Your back panels are now completely removed.
Follow the wires from the panels to the motherboard.
You may need to cut any zip ties that are holding the wires together.
There is one connection on the battery side and three on the other side that must be removed.
These connections may be difficult to remove. Try to securely press the connection and pull firmly.
Your back panels are now completely removed.
Step 4
Gyroscope
- Disconnect the gyroscope by disconnecting the wires attached to it. These wires are black, green, blue and red.
Disconnect the gyroscope by disconnecting the wires attached to it. These wires are black, green, blue and red.
Step 5
- Using your Phillips #2 screwdriver, remove the four 8mm screws marked in red from the gyroscope.
Using your Phillips #2 screwdriver, remove the four 8mm screws marked in red from the gyroscope.
Step 6
- Carefully remove the gyroscope component from the SwagTron.
Carefully remove the gyroscope component from the SwagTron.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
9 other people completed this guide.
Author
with 3 other contributors
Teagan Allen
Member since: 04/18/2017
417 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team S17-G5, Banghart Spring 2017
Member of Cal Poly, Team S17-G5, Banghart Spring 2017
CPSU-BANGHART-S17S17G5
4 Members
5 Guides authored
Gavin Hosler - Jun 19, 2018
Reply
I cannot find a Swagtron T1 replacement gyroscope anywhere on the internet. Any help would be extremely appreciated!! Thank you!
Jesse Griffis - Jul 23, 2018
Brittany Conner - Nov 5, 2018
Reply
Where do you get the replacement?
jbswearingen70739 - Feb 6, 2019
Reply
Can’t find gyroscope for a t5 hover board please help.