Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Camera
- 4 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackSupersonic SC-777BT
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Camera
- Remove the back cover using the plastic opening tool.
- Open the cover like a book so you do not disconnect the yellow plastic holding the cover to the motherboard.
Remove the back cover using the plastic opening tool.
Open the cover like a book so you do not disconnect the yellow plastic holding the cover to the motherboard.
1024
Step 2
- Remove the two screws using the screwdriver.
- Use the tweezers to pull the camera out of place.
- Be gentle while pulling it out so you do not pull any extra components out.
Remove the two screws using the screwdriver.
Use the tweezers to pull the camera out of place.
Be gentle while pulling it out so you do not pull any extra components out.
Step 3
- Disconnect the yellow ribbon cable from the connector.
Disconnect the yellow ribbon cable from the connector.
Step 4
- Remove camera.
- It should just peel off like a sticker.
Remove camera.
It should just peel off like a sticker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Maiya Webster
Member since: 09/18/2018
364 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
University of North Texas, Team S4-G4, Raign Fall 2018
Member of University of North Texas, Team S4-G4, Raign Fall 2018
UNT-RAIGN-F18S4G4
3 Members
8 Guides authored