Difficulty
Moderate
Steps
4
Time Required
15 minutes
Sections
2
- Outer Case
- 2 steps
- Power Switch
- 2 steps
Flags
0
BackSuper Nintendo
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Case
- Remove the six screws located on the underside of the system using the Gamebit 4.5mm screwdriver.
Remove the six screws located on the underside of the system using the Gamebit 4.5mm screwdriver.
1024
Step 2
- Carefully flip the unit back over.
- Locate the seam. Lift and separate the upper half of the case from the lower half of the case.
Carefully flip the unit back over.
Locate the seam. Lift and separate the upper half of the case from the lower half of the case.
Step 3
Power Switch
- Remove the two 11.7 mm Phillips #2 screws connecting the power switch to the motherboard.
Remove the two 11.7 mm Phillips #2 screws connecting the power switch to the motherboard.
Step 4
- The power switch is connected to the motherboard near the top left of the console.
- Carefully pull the connector from its socket on the motherboard. You may need to wiggle it out as you pull.
- Do not detach the connector by pulling on the wires. This could damage the wires or the socket.
The power switch is connected to the motherboard near the top left of the console.
Carefully pull the connector from its socket on the motherboard. You may need to wiggle it out as you pull.
Do not detach the connector by pulling on the wires. This could damage the wires or the socket.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
16 other people completed this guide.
Author
with 11 other contributors
Cameron Deines
Member since: 10/05/2010
697 Reputation
2 Guides authored
Badges:
13
+10 more badges
Team
Cal Poly, Team 4-47, Amido Fall 2010
Member of Cal Poly, Team 4-47, Amido Fall 2010
CPSU-AMIDO-F10S4G47
4 Members
20 Guides authored