Difficulty

Moderate

Steps

4

Time Required

                          15 minutes            

Sections

2

  • Outer Case
  • 2 steps
  • Eject Button
  • 2 steps

Flags

0

  • BackSuper Nintendo

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Case               
  • Remove the six screws located on the underside of the system using the Gamebit 4.5mm screwdriver.

Remove the six screws located on the underside of the system using the Gamebit 4.5mm screwdriver.

1024

Step 2

  • Carefully flip the unit back over.
  • Locate the seam. Lift and separate the upper half of the case from the lower half of the case.

Carefully flip the unit back over.

Locate the seam. Lift and separate the upper half of the case from the lower half of the case.

Step 3

              Eject Button               
  • Lift the right side of the eject lever out of the housing.

Lift the right side of the eject lever out of the housing.

Step 4

  • Pull the metal bar out through the right side of the eject lever.
  • Make sure to keep track of the spring located on the left side of the lever as it may shoot off when removing the metal bar.
  • When reassembling, the procedure becomes more difficult due to the spring (marked red). We recommend that one person hold the spring in place (picture 3) while another person slides the metal bar back into the left housing, and slide the eject lever onto the metal bar.

Pull the metal bar out through the right side of the eject lever.

Make sure to keep track of the spring located on the left side of the lever as it may shoot off when removing the metal bar.

When reassembling, the procedure becomes more difficult due to the spring (marked red). We recommend that one person hold the spring in place (picture 3) while another person slides the metal bar back into the left housing, and slide the eject lever onto the metal bar.

To reassemble your device, follow the instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      9 other people completed this guide.                                             

Author

                                      with 10 other contributors 

                    James Shirley                     

Member since: 10/03/2010

952 Reputation

                                      2 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       Cal Poly, Team 4-47, Amido Fall 2010                        

                                                  Member of Cal Poly, Team 4-47, Amido Fall 2010 



                    CPSU-AMIDO-F10S4G47                     


                                            4 Members                     


                                            20 Guides authored