Difficulty

Moderate

Steps

3

Time Required

                          20 seconds - 1 minute

Sections

1

  • Staple
  • 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackStapler

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Step 1

              Open & Identify
  • Be careful while handling staples or any sharp object in general.
  • Grab the base of the stabler, and pull the hammer until the stapler opens, revealing the carrier, pusher, and spring.
  • Identify the staple type by looking on the bottom of the carrier. If the staple type is not on the carrier, look under the base.

Be careful while handling staples or any sharp object in general.

Grab the base of the stabler, and pull the hammer until the stapler opens, revealing the carrier, pusher, and spring.

Identify the staple type by looking on the bottom of the carrier. If the staple type is not on the carrier, look under the base.

1024

Step 2

              Insert Staples
  • Get a cluster of staples and carefully place it in the carrier.
  • Make sure there is enough room for the pusher to contact the staples.
  • Close the stapler by clearing your hand from under the crimp area and pushing the hammer down until a clicking sound is heard.

Get a cluster of staples and carefully place it in the carrier.

Make sure there is enough room for the pusher to contact the staples.

Close the stapler by clearing your hand from under the crimp area and pushing the hammer down until a clicking sound is heard.

Step 3

  • Don’t staple your hand, or anyone else for that matter.
  • Congratulations! You have successfully replaced staples in your stapler.

Don’t staple your hand, or anyone else for that matter.

Congratulations! You have successfully replaced staples in your stapler.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      7 other people completed this guide.

Author

                                      with 4 other contributors 


                    Sequoia Equities

Member since: 01/22/2015

225 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Brian Gray - Jul 7, 2022

Reply

Wnen I tried to load the staples, the spring came loose. But I do not know where to reconnect it and have a loose short plastic rod!