Difficulty
Moderate
Steps
5
Time Required
20 minutes
Sections
1
- Battery
- 5 steps
Flags
2
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackSRM Power Meter
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
In case you are lucky to get a later model, I believe the battery replacement can now be performed by yourself.
Good Luck!
What you need
Step 1
Open the Power Meter
- Remove the chain rings. On some models there are little screws to open the cap. On my FSA Model there is a tab to pop open the cap.
- Make sure the seals stay intact.
- There are 2 batteries glued in. They are connected with a power cable that has a little 2 pin plug.
Remove the chain rings. On some models there are little screws to open the cap. On my FSA Model there is a tab to pop open the cap.
Make sure the seals stay intact.
There are 2 batteries glued in. They are connected with a power cable that has a little 2 pin plug.
1024
Step 2
Remove Batteries
- ATTENTION: Make sure you don’t damage the thin cooper wires marked in yellow.
- Unplug the batteries from the circuit board. (red)
- With the solder gun remove the cables from the old batteries. Make sure not to melt the cables or plug.
ATTENTION: Make sure you don’t damage the thin cooper wires marked in yellow.
Unplug the batteries from the circuit board. (red)
With the solder gun remove the cables from the old batteries. Make sure not to melt the cables or plug.
Step 3
Prepare new Batteries
- My batteries had mounting pins attached to the silver side. They have to be remove with pliers.
- The terminal pins have to be bent straight.
- Finally the pins have to be cut to the same length as the old batteries.
My batteries had mounting pins attached to the silver side. They have to be remove with pliers.
The terminal pins have to be bent straight.
Finally the pins have to be cut to the same length as the old batteries.
Step 4
Attach Wires
- Add heat shrink to cables and solder them to battery. Red to (+) and black to (-)
- Push the heat shrink up to cover the entire pin and soldering connection.
- Twist the wired back together gently.
Add heat shrink to cables and solder them to battery. Red to (+) and black to (-)
Push the heat shrink up to cover the entire pin and soldering connection.
Twist the wired back together gently.
Step 5
Insert the Batteries
- Attach the new batteries. There is a + on the circuit board on the side where the red wire goes.
- Push the batteries gently back into place.
- Connect the power meter and check the battery status of the sensor. On my Garmin I see NEW.
Attach the new batteries. There is a + on the circuit board on the side where the red wire goes.
Push the batteries gently back into place.
Connect the power meter and check the battery status of the sensor. On my Garmin I see NEW.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
midiman127
Member since: 04/27/2010
740 Reputation
2 Guides authored
Badges:
11
+8 more badges