Spy Net Ultra Vision Goggles Microsd Card Reader Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          45 - 55 minutes

Sections

MicroSD Card Reader
5 steps

Flags

BackSpy Net Ultra Vision Goggles
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Opening the Device

Remove the six silver 11.4 mm Phillips #0 screws
Pry open the device using a plastic opening tool if necessary. To do this, locate the groves running along the side of the entire device and wedge it open.

Remove the six silver 11.4 mm Phillips #0 screws

Pry open the device using a plastic opening tool if necessary. To do this, locate the groves running along the side of the entire device and wedge it open.

1024

Step 2

              Removing the Styrofoam Pad

Now that your device is open, remove the Styrofoam pad that covers the main circuit board. The adhesive should allow you to remove and replace it with ease.
Do this carefully to avoid tearing the pad.

Now that your device is open, remove the Styrofoam pad that covers the main circuit board. The adhesive should allow you to remove and replace it with ease.

Do this carefully to avoid tearing the pad.

Step 3

              Removing the Circuit Board

Remove the eight black 7.2 mm Phillips #0 screws from the top of the circuit board and remove the circuit board.

Remove the eight black 7.2 mm Phillips #0 screws from the top of the circuit board and remove the circuit board.

Step 4

              Removing The Micro SD Reader

Unscrew the one 7.2 mm Phillips #0 screw from the plastic piece covering the microSD reader.
Then, unscrew the two 7.2 mm Phillips #0 screws from the microSD reader and remove it from its fastening.

Unscrew the one 7.2 mm Phillips #0 screw from the plastic piece covering the microSD reader.

Then, unscrew the two 7.2 mm Phillips #0 screws from the microSD reader and remove it from its fastening.

Step 5

              Un-Soldering the Wires

On the back side of the reader there are nine wires. Un-solder these wires, remove the micro SD card reader, and solder on the replacement.
Need Help Soldering? Check out How To Solder and Desolder Connections for tips.

On the back side of the reader there are nine wires. Un-solder these wires, remove the micro SD card reader, and solder on the replacement.

Need Help Soldering? Check out How To Solder and Desolder Connections for tips.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Andrew Gittens

Member since: 09/22/2014

143 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 4-5, Brown Fall 2014                        

                                                  Member of USF Tampa, Team 4-5, Brown Fall 2014 



                    USFT-BROWN-F14S4G5                     


                                            3 Members                     


                                            6 Guides authored

clsutliff - Jun 25, 2017

Where do you get the replacement parts?

Introduction#

What you need#

Team#

Introduction

What you need

Team