Spin Master Hatchimal Draggle Wheels Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Plastic Wing Replacement
3 steps
Fur Replacement
8 steps
Wheel Replacement
3 steps

Flags

BackSpin Master Hatchimal Draggle
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Plastic Wing Replacement

lay the Hatchimal on its side.

lay the Hatchimal on its side.

1024

Step 2

Using the plastic opening tool, push in on the purple clip.

Using the plastic opening tool, push in on the purple clip.

Step 3

Pull the wing off of the hatchimal.
The wing should come off with little resistance.

Pull the wing off of the hatchimal.

The wing should come off with little resistance.

Step 4

              Fur Replacement

Cut the fur retaining zip-tie with a pair of scissors.

Cut the fur retaining zip-tie with a pair of scissors.

Step 5

Lift the fur up until it can’t go further.

Lift the fur up until it can’t go further.

Step 6

Use the spudger tool to push up on the black clip to free it.
Pull the clip out.

Use the spudger tool to push up on the black clip to free it.

Pull the clip out.

Step 7

Lift fur up to reveal the next set of clips.
Insert a spudger to push up on the black clip to free it.
Pull out the clip.

Lift fur up to reveal the next set of clips.

Insert a spudger to push up on the black clip to free it.

Pull out the clip.

Step 8

Lift the fur up and over the Hatchimals Head.
Remove the six 12mm Phillips #00 screws from then body.

Lift the fur up and over the Hatchimals Head.

Remove the six 12mm Phillips #00 screws from then body.

Step 9

Pull the casing apart.
Remove the yellow speaker cable.

Pull the casing apart.

Remove the yellow speaker cable.

Step 10

Remove the three 7mm Phillips #00 screws from the head.
Remove the wheel base and the circuit board carefully not to damage the spring.

Remove the three 7mm Phillips #00 screws from the head.

Remove the wheel base and the circuit board carefully not to damage the spring.

Step 11

Push the six black fur clips out using the spudger.
Remove the fur completely.

Push the six black fur clips out using the spudger.

Remove the fur completely.

Step 12

              Wheel Replacement

Lift up and remove the light blue plastic casing.

Lift up and remove the light blue plastic casing.

Step 13

Remove the six 7mm Phillips #00 screws.

Remove the six 7mm Phillips #00 screws.

Step 14

Remove the purple plastic casing. It should come off with little resistance.
Remove the wheel.

Remove the purple plastic casing. It should come off with little resistance.

Remove the wheel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Humaid Alhajri

Member since: 02/14/2018

115 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USF Tampa, Team S1-G5, Nance Spring 2018                        

                                                  Member of USF Tampa, Team S1-G5, Nance Spring 2018 



                    USFT-NANCE-S18S1G5                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team