Spin Master Boxer Remote Trigger Buttons Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          5 minutes            

Sections

1

• Remote Trigger Buttons
• 5 steps

Flags

0

• BackSpin Master Boxer

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remote Trigger Buttons               

• Lay the remote flat on your work space, with joysticks facing you.

Lay the remote flat on your work space, with joysticks facing you.

1024

Step 2

• Remove both joysticks by gripping under circular knob and gently pulling towards you.
• The joysticks should detach without much effort.

Remove both joysticks by gripping under circular knob and gently pulling towards you.

The joysticks should detach without much effort.

Step 3

• Use the Phillips #00 Screwdriver to remove 4mm screw on the center battery panel.
• Remove the batteries from the remote and set it to side.
• Use the same screwdriver to remove all four 4mm screws on back panel.

Use the Phillips #00 Screwdriver to remove 4mm screw on the center battery panel.

Remove the batteries from the remote and set it to side.

Use the same screwdriver to remove all four 4mm screws on back panel.

Step 4

• Insert the Jimmy in between the top panel and the bottom panel.
• Gently use the Jimmy to separate both plastic panels from each other.
• Pull the panels apart and set bottom piece on workbench.

Insert the Jimmy in between the top panel and the bottom panel.

Gently use the Jimmy to separate both plastic panels from each other.

Pull the panels apart and set bottom piece on workbench.

Step 5

• Pinch the trigger between index finger and thumb, and lift up, away from circuit board.
• Inspect the square button attached to circuit board to ensure functionality. If there is an issue with connection, a new circuit boards may be required.

Pinch the trigger between index finger and thumb, and lift up, away from circuit board.

Inspect the square button attached to circuit board to ensure functionality. If there is an issue with connection, a new circuit boards may be required.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Lauren Roide                     

Member since: 04/16/2019

739 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team S1-G1, Maness Spring 2019                        

                                                  Member of Cal Poly, Team S1-G1, Maness Spring 2019 



                    CPSU-MANESS-S19S1G1                     


                                            4 Members                     


                                            5 Guides authored