Difficulty
Easy
Steps
5
Time Required
15 minutes
Sections
2
- Tires and Hubcaps
- 2 steps
- Motherboard
- 3 steps
Flags
1
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackSphero Ollie
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Tires and Hubcaps
- Firmly grasp Ollie in one hand.
- Remove the blue rubber tire in a peeling motion with your opposite hand.
Firmly grasp Ollie in one hand.
Remove the blue rubber tire in a peeling motion with your opposite hand.
1024
Step 2
- Continue to firmly hold Ollie in one hand.
- Use a Plastic Opening Tool to gently pry off the hubcap.
- Avoid inserting the Plastic Opening Tool into the empty holes, but instead use the tool near the tabs holding the hubcap in.
- Do not aim the hubcap towards another person as it may pop off with force.
Continue to firmly hold Ollie in one hand.
Use a Plastic Opening Tool to gently pry off the hubcap.
Avoid inserting the Plastic Opening Tool into the empty holes, but instead use the tool near the tabs holding the hubcap in.
Do not aim the hubcap towards another person as it may pop off with force.
Step 3
Motherboard
- Loosen and remove the 10mm screw on each side of the device using a JIS 1 screwdriver tip.
- Remove the plastic tire frame from the device
Loosen and remove the 10mm screw on each side of the device using a JIS 1 screwdriver tip.
Remove the plastic tire frame from the device
Step 4
- Loosen and remove the four 10mm Screws on the underside of the device using a JIS 1 tip.
- Firmly grasp the bottom of the device and pull the top half of the outer case off of the bottom.
Loosen and remove the four 10mm Screws on the underside of the device using a JIS 1 tip.
Firmly grasp the bottom of the device and pull the top half of the outer case off of the bottom.
Step 5
- Loosen and remove the 10mm screws holding the blue tooth connector as well as the two 1 10 screws holding the motherboard to the case using the JIS #1 screwdriver
- Loosen and remove the 10mm screws holding the antenna to the case.
- Gently remove mother board from the case with an upward motion.
Loosen and remove the 10mm screws holding the blue tooth connector as well as the two 1 10 screws holding the motherboard to the case using the JIS #1 screwdriver
Loosen and remove the 10mm screws holding the antenna to the case.
Gently remove mother board from the case with an upward motion.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Krystal Hedrick
Member since: 10/30/2017
352 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
UW Tacoma, Team S1-G3, Rose Fall 2017
Member of UW Tacoma, Team S1-G3, Rose Fall 2017
UWT-ROSE-F17S1G3
4 Members
5 Guides authored