Difficulty

Moderate

Steps

7

Time Required

                          15 - 45 minutes            

Sections

1

  • Charging Pins
  • 7 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSoundcore Liberty Air

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Charging Pins               
  • Clean the charging pins and case with a cotton swab.

Clean the charging pins and case with a cotton swab.

1024

Step 2

  • Remove the flat cover with a 1/16" punch tool by inserting it into the divot at the top of the earbud.
  • Be careful not to push too hard or upwards.
  • There is a lot of adhesive securing the cover, so using a mild heat will help loosen the adhesive.

Remove the flat cover with a 1/16" punch tool by inserting it into the divot at the top of the earbud.

Be careful not to push too hard or upwards.

There is a lot of adhesive securing the cover, so using a mild heat will help loosen the adhesive.

Step 3

  • Remove the black rubber cross from the bottom of the earbud with angled tweezers.
  • Do not poke through the rubber.

Remove the black rubber cross from the bottom of the earbud with angled tweezers.

Do not poke through the rubber.

Step 4

  • Remove the top rubber rectangle with angled tweezers.

Remove the top rubber rectangle with angled tweezers.

Step 5

  • Remove the white block from the earbud with blunt tweezers.

Remove the white block from the earbud with blunt tweezers.

Step 6

  • Push out charging pins with the 1/16" tool.
  • Pull out the rest of the charging pin with angled tweezers

Push out charging pins with the 1/16" tool.

Pull out the rest of the charging pin with angled tweezers

Step 7

  • Replace charging pins with angled tweezers.

Replace charging pins with angled tweezers.

To reassemble your device, follow these instructions in reverse order. Make sure to add all black rubber squares back in the same position that you removed them in order for them to fit properly. Avoid getting any moisture in or around the device during the repair in order to prevent any type of water damage.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Alyssa Punturo                     

Member since: 09/21/2022

145 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       CSU Fullerton, Team 1-3, Bruce Fall 2022                        

                                                  Member of CSU Fullerton, Team 1-3, Bruce Fall 2022 



                    CSUF-BRUCE-F22S1G3                     


                                            2 Members                     


                                            1 Guide authored