Difficulty
Moderate
Steps
12
Time Required
10 - 20 minutes
Sections
1
- Power supply
- 12 steps
Flags
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
BackSanyo pro extraX multiverse projector
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Bottom Panel
- Place the projector upside-down to access the screws on the bottom.
- Remove five 9mm long screws with a Phillips 1 screwdriver.
Place the projector upside-down to access the screws on the bottom.
Remove five 9mm long screws with a Phillips 1 screwdriver.
1024
Step 2
- Turn the projector on its side.
- Remove one 9mm Phillips 1 screw
Turn the projector on its side.
Remove one 9mm Phillips 1 screw
Step 3
- Place the projector right side up and lift the top panel up and put it to the side.
Place the projector right side up and lift the top panel up and put it to the side.
Step 4
- Locate the metal panel on the right hand side.
- Remove two 7mm screws
Locate the metal panel on the right hand side.
Remove two 7mm screws
Step 5
- Lift the panel up slightly and forward to remove it completely.
Lift the panel up slightly and forward to remove it completely.
Step 6
Motherboard
- Remove five 9mm screws with a Phillips 1 screwdriver
- Remove one 11mm screws with a Phillips one screwdriver
Remove five 9mm screws with a Phillips 1 screwdriver
Remove one 11mm screws with a Phillips one screwdriver
Step 7
- Remove two 5mm screws with a Phillips 2 screwdriver
Remove two 5mm screws with a Phillips 2 screwdriver
Step 8
- Remove all clips from mother board.
- There are two additional clips underneath the mother board that need to be disconnected as well.
Remove all clips from mother board.
There are two additional clips underneath the mother board that need to be disconnected as well.
Step 9
ribbon cables
- To remove the ribbon cables, lift up on the black hinge with a fingernail or the tip of your spudger.
- Now, use a spudger or a barbecue skewer to lift the cable out.
To remove the ribbon cables, lift up on the black hinge with a fingernail or the tip of your spudger.
Now, use a spudger or a barbecue skewer to lift the cable out.
Step 10
- Lift the board up slowly, making sure there are no snagged cables.
- Unplug the two power cables coming into the board.
- Remove the mother board from the device.
Lift the board up slowly, making sure there are no snagged cables.
Unplug the two power cables coming into the board.
Remove the mother board from the device.
Step 11
- Remove two clips by pinching and pulling up on the connector.
Remove two clips by pinching and pulling up on the connector.
Step 12
- You can now remove the power supply.
You can now remove the power supply.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Matt Block
Member since: 11/30/2017
256 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,769 Guides authored