Featured
Featured Guide
Difficulty
Moderate
Steps
4
Time Required
25 minutes
Sections
1
- Back Cover
- 4 steps
Flags
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackSony Xperia Z3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Heat the back cover of your Xperia Z3 to loosen the adhesive underneath.
- If you use an iOpener, follow these instructions for use.
- Lift up the back cover with a suction handle and put an opening pick in the gap.
- Move the pick carefully around the edges to loosen the adhesive on every side of the phone.
- Don’t put the pick in too deep under the back cover to not damage any parts inside the phone.
Heat the back cover of your Xperia Z3 to loosen the adhesive underneath.
If you use an iOpener, follow these instructions for use.
Lift up the back cover with a suction handle and put an opening pick in the gap.
Move the pick carefully around the edges to loosen the adhesive on every side of the phone.
Don’t put the pick in too deep under the back cover to not damage any parts inside the phone.
1024
Step 2
- There are two adhesive strips in the center of the phone connecting the rear case to the battery, you’ll need to remove them to open the phone.
- When the edges of the cover are free from adhesive, tilt it to allow access to the battery tabs.
- Use tweezers to pull the two black adhesive strips out of the phone but don’t pull just yet.
There are two adhesive strips in the center of the phone connecting the rear case to the battery, you’ll need to remove them to open the phone.
When the edges of the cover are free from adhesive, tilt it to allow access to the battery tabs.
Use tweezers to pull the two black adhesive strips out of the phone but don’t pull just yet.
Step 3
- Gently pull out both of the adhesive tabs out of the phone, parallel to the rear cover.
- If the adhesive tabs break, try to use a thin flat plastic tool such as a plastic card to remove the last of the adhesive. If the adhesive is stubborn, heat it with an iOpener or hair dryer and pry again.
Gently pull out both of the adhesive tabs out of the phone, parallel to the rear cover.
If the adhesive tabs break, try to use a thin flat plastic tool such as a plastic card to remove the last of the adhesive. If the adhesive is stubborn, heat it with an iOpener or hair dryer and pry again.
Step 4
- After pulling out the adhesive tabs, you can lift the back cover and remove it.
After pulling out the adhesive tabs, you can lift the back cover and remove it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 4 other contributors
Tobias Isakeit
Member since: 03/31/2014
105,397 Reputation
184 Guides authored
Badges:
46
+43 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,769 Guides authored